SENSOR GP-POSITION 2047951 - Caterpillar

Personal injury or death can result from machine articulation or movement.Machine frames can move and a person can be crushed.Connect the steering frame lock link between the front and rear frames before working on machine.
Note: If the steering wheel or the steering shaft is removed, the components must be installed correctly.
Center the machine in the STRAIGHT AHEAD position.
Stop the engine. Engage the parking brake.
Illustration 1 g00460133
Steering Frame Lock in the Locked position (1) Steering frame lock.
Install steering frame lock (1) in order to prevent machine articulation.
Illustration 2 g00428074
Steering Components (2) Pilot control valve. (3) Key. (4) Shaft. (5) Flange. (6) Steering Wheel. (7) Steering shaft. (8) Key. (9) Shaft. (10) Yoke. (11) Bolt. (12) Lever. (13) Bolt.
Remove steering shaft assembly (7) .Reference: For the correct procedure to remove the steering shaft, refer to the Service Manual module for Disassembly and Assembly, "Steering Shaft - Remove and Install" for the machine that is being serviced.
Illustration 3 g00428129
View B-B (10) Yoke. (11) Bolt. (14) Keyway. (15) Nut.Note: Key (3) and keyway (14) should be in the STRAIGHT AHEAD position.
Align keyway (14) with key (3) .
Install yoke (10) onto shaft (4) .Note: Be sure that key (3) is still in place once you install yoke (10) onto shaft (4) .
Install bolt (11) and nut (15) into yoke (10). Tighten nut (15) to a torque of 55 10 N m (40 7 lb ft).
Position keyway (8) in the STRAIGHT AHEAD position. Steering wheel (6) must also be in the STRAIGHT AHEAD position.Note: If steering wheel (6) is not in the STRAIGHT AHEAD position, steering wheel (6) must be removed and aligned with keyway (8). When the components are correctly aligned, the steering wheel will turn evenly to the right and to the left.
Illustration 4 g00428130
Detail C (8) Keyway. (9) Shaft. (12) Lever. (13) Bolt. (A) 6.0 1.0 mm (.25 .05 inch).
Install lever (12) onto shaft (9). Slide lever (12) over key (8) until you obtain dimension (A). Dimension (A) equals 6.0 1.0 mm (.25 .04 inch).
Secure lever (12) to shaft (9) with bolt (13). Tighten bolt (13) to a torque of 55 10 N m (40 7 lb ft).
Illustration 5 g00428128
View A-A (5) Flange. (16) Pilot hole.Note: Be sure that steering wheel (6) is in the STRAIGHT AHEAD position before you perform the following steps.
Assemble shaft (9) into pilot hole (16) that is located in flange (5) .
Illustration 6 g00417447
Steering Components (5) Flange. (12) Lever. (13) Bolt. (17) Bolts. (18) Washers. (19) Nuts.
Attach flange (5) to lever (12) with bolts (17), washers (18), and nuts (19) .
Illustration 7 g00476729
Lever to Flange (5) Flange. (12) Lever. (17) Bolt heads.Note: Be sure that there is no space between flange (5) and lever (12) before performing Step 14.
Be sure that flange (5) is flush against lever (12) .
Tighten nuts (19) that are on bolts (17) .