SENSOR GP-POSITION 2192392 - Caterpillar

Illustration 8 g03579576
Location and torque for 387-0276 Hose As and 1P-4278 Hose Clamp (22) 387-0276 Hose As (24) 1P-4278 Hose Clamp (L1) Center line of fan (R1) 117.5 5 mm (4.63 0.2 inch) (R2) 187 5 mm (7.36 0.2 inch)
Install 387-0276 Hose As (22) with 1P-4278 Hose Clamp (24) and 211-8071 Protective Cap (23) to the 301-7312 Fan (9). Orient clamp as shown and torque 1P-4278 Hose Clamp (24) to 2.5 N m (22 lb in)
Install the 325-9620 Baffle As (2) with 8T-4195 Bolt (V) and 7X-7729 Washer (W) .
Install the 334-4637 Motor Support As (3) to the cooling system. Install 387-0276 Hose As (22) with 2Y-5429 Grommet (21.)
Install 325-9619 Baffle As (1)
Illustration 9 g03337152
View of 387-0267 Air Lines Gp .
Illustration 10 g03338237
Refer to Special Instruction, REHS7738, "Procedure to Replace the Air Control Valve on Certain 950K through 980K Wheel Loaders " for information to install the components in Illustration 10.
Illustration 11 g03336964
(CA) 372-4149 Hose As (CA)
Use the following steps to Install components in Illustration 11.
Illustration 12 g03389684
Attach the 338-3647 Tube As (37). This tube assembly will replace the existing 324-8126 Tube in that location.
Connect 325-9624 Hose As (39) to 148-8368 Elbow As (38). Connect elbow assembly (38) to 338-3647 Tube As (37) .
Install 325-9624 Hose As (39) to existing 372-4149 Hose As (CA) with 202-2762 Clips (19), 9X-8250 Clips (42), 8T-4136 Bolts (14), 8T-4121 Hard Washers (17), and 8T-4133 Nuts (43) .
Attach 338-2743 Hose As (40) and 148-8315 Connector (41). This hose assembly will replace the existing 323-4559 Hose As and connector in that location.
Install the 346-1067 Relay Gp (44). Assemble the relays in position 6. Attach 338-3647 Tube As (37) .
Install the 225-4130 Film (45) on machines that are located in North America. Install the 225-4131 Film (46) on machines located outside North America. Install the film over the previous film located on the sides of the radiator group.Software Configuration and Calibration of the 387-1357 Fan Control Arrangement (Variable Pitch Fan)
Note: This feature can be configured and must be activated with Product Software Programming System (PSPS) or a service tool.
Use aCaterpillar Electronic Technician (Cat ET) and select the proper Electronic Control Module (ECM). Select "SERVICE" from the menu.
Select "CONFIGURATION" from the menu.
Double click on the desired feature on the configuration screen.
Select the desired status of the feature and click "OK". The feature will be activated on the next power cycle.