SENSOR GP-ENGINE 2325299 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     FT-1897     Bracket     1    
138-7575 Link Bracket     2    
C     180-3033     Stand     1    
D     8S-9906     Ratchet Puller     1    
E     138-7573     Link Bracket     2    
F     138-7574     Link Bracket     2    Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 1 g00869911
Illustration 2 g00869923
Attach Tooling (F) to the transmission and bevel gears (15). Install the transmission and bevel gears. Use a pry bar to balance the transmission and bevel gears (15). The weight of transmission and bevel gears is approximately 816 kg (1800 lb).
Illustration 3 g00869900
Install bolts (6) and cover (7) and attach Tooling (E). Attach a suitable lifting device to Tooling (E). Lift the transmission and bevel gears on the rails. Allow the transmission to rest on the ripper. Remove Tooling (E). Remove bolts (6) and cover (7) .
Illustration 4 g00869833
Attach Tooling (D) and lower the link. Install the pin on the left hand link (14) .
Illustration 5 g00869829
Illustration 6 g00869817
Place the transmission and bevel gears (15) on Tooling (C) .
Install bolts (8) and cover (9). Install Tooling (A). Attach a suitable lifting device to Tooling (A). Install the transmission and bevel gears. Remove Tooling (A) .
Illustration 7 g00869820
Connect harness assembly (12). Install bolts (13) .
Illustration 8 g00869763
Install cover (10). Connect tube assembly (11) .
Illustration 9 g00869704
Install bolts (4) and install guard (5). Install cover (7) and install bolts (6) .
Illustration 10 g00869668
Install guard assembly (3). Install bolts (1) and bolts (2) .
Fill the power train oil system. The capacity of the power train oil system is 148 L (38.5 US gal).
Attach a suitable lifting device to the ripper assembly. Install the cylinder pin and remove the suitable lifting device.End By:
Install the axles. Refer to Disassembly and Assembly, "Axle - Remove and Install".
Install the drive shaft. Refer to Disassembly and Assembly, "Drive Shaft - Remove and Install".