SENSOR GP- 2679672 - Caterpillar

Illustration 8 g01371647
Crushing Hazard. There is no clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur. Connect the steering frame lock between front and rear frames before lifting, transporting, or servicing the machine in the articulation area.Disconnect the steering lock and secure before resuming operation.
No Clearance (8)This warning label is located on the side face of the loader frame near the articulation hitch on both sides of the machine.
Illustration 9 g01371644
Stay back a safe distance. No clearance for a person in this area when the machine turns. Severe injury or death from crushing could occur.
Seat Belt (9)This warning label is located inside the cab on the RH window.
Illustration 10 g01371636
A seat belt should be worn at all times during machine operation to prevent serious injury or death in the event of an accident or machine overturn. Failure to wear a seat belt during machine operation may result in serious injury or death.
Hot Surface (10)This warning label is located on the lower front face of the end cap for the air cleaner housing on the left side of the machine.
Illustration 11 g01384734
Burn Hazard: Engine components may be hot during and after machine operation.Hot components can cause serious personal injury. Do not contact hot components with bare skin.
ROPS/FOPS Structure (11)This warning label is located above the platform on the right side of the cab to the left of the door.
Illustration 12 g01212098
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. This will void the certification. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification plate. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification plate.Product Link (12)This warning label is located inside the cab on the left front post.
Illustration 13 g01370917
This machine is equipped with a Caterpillar Product Link communication device. When electric/electronic detonators are used, this communication device should be deactivated within 12 m (40 ft) of a blast site, or within the distance mandated under applicable legal requirements. Failure to do so could cause interference with blasting operations and result in serious injury or death.
High Pressure Cylinder (13)This warning label is located on the ride control accumulator in the service center on the right side of the machine.
Illustration 14 g01370912
Gas under pressure. Rapid discharge from disconnecting or disassembly could cause personal injury or death. See service manual before relieving pressure or charging.