SENSOR GP-LIQUID LEVEL 2855105 - Caterpillar

Attach a "DO NOT OPERATE" or similar warning tag to start switch or controls before servicing or repairing the machine. These tags, Form SEHS7332, are available from your Caterpillar dealer.Lubrication, maintenance or repair of the machine can be dangerous unless performed properly. Each person must satisfy himself that he has the necessary skill and information, proper tools and equipment, and that his work method is safe and correct. Caterpillar dealers are available to provide service and information.Caution should be used to avoid breathing dust that may be generated when handling components containing asbestos fibers. If this dust is inhaled, it can be hazardous to your health. Components in Caterpillar products that may contain asbestos fibers are brake pads, brake band and lining assemblies, clutch plates and some gaskets. The asbestos used in these components is usually bound in a resin or sealed in some way. Normal handling is not hazardous as long as airborne dust which contains asbestos is not generated.If dust which may contain asbestos is present, there are several common sense guidelines that should be followed.1. Never use compressed air for cleaning.2. Avoid brushing or grinding of asbestos containing materials.3. For clean up, use wet methods or vacuum equipped with a high efficiency particulate air (HEPA) filter.4. Use exhaust ventilation on permanent machining jobs.5. Wear an approved respirator is there is no other way to control the dust.6. Comply with applicable rules and regulations for the work place (for example in the U.S.A. OSHA requirements as set forth in 29 CFR 1910.1001).7. Follow environmental rules and regulations for disposal of asbestos.8. Avoid areas where asbestos particles may be in the air.The engine stopped.The start switch key off and the key removed.To avoid possible weakening of the ROPS, consult a Caterpillar dealer before altering ROPS in any way. The protection offered by this ROPS will be impaired if it has been subjected to structural damage or has been involved in an overturn incident.Wear a hard hat, protective glasses and other protective equipment as required by job conditions.Do not wear loose clothing or jewelry that can catch on controls or other parts of the machine.Make certain all protective guards and covers are secured in place on the machine.Keep the machine, especially the deck, walkways and steps, free of foreign material, such as debris, oil, tools and other items which are not part of the machine.Secure all loose items such as lunch boxes, tools and other items which are not part of the machine.Know the hand signals and who gives them. Accept signals from one person only.Never put maintenance fluids into glass containers.Report all needed repairs.Do not allow unauthorized personnel on the machine.When using pressure air for cleaning, wear a protective face shield and protective clothing.Maximum air pressure from the nozzle must be less than 205 kPa (30 psi) for cleaning purposes.