SENSOR GP-PRESSURE 2993222 - Caterpillar

Removal Procedure
Start By:
Remove the rear crankcase guard.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, PERJ1017, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Drain the transmission into a suitable container.
Illustration 1 g06249582
Remove bolts (1). Remove oil pan (2).
Illustration 2 g06249604
Remove bolts (3). Remove suction tube assembly (4) and the O-ring seal.
Illustration 3 g06249620
Remove bolt (6) and the clip.
Remove bolt (5) and bolt (8).
Remove tube (7) and the O-ring seals.
Illustration 4 g06249643
Remove bolts (10). Remove bolts (11).
Remove tube assembly (9) and the O-ring seals.
Illustration 5 g06249653
Remove nut (13) and push connector (12) through the housing.
Illustration 6 g06249692
Disconnect electrical connectors (14) and position out of the way.
Illustration 7 g06249733
Remove bolts (15). Remove manifold assembly (16).
Illustration 8 g06250151
Remove gasket (17).
Remove bolts (18) and plate (19).Installation Procedure
Install transmission hydraulic control manifold assembly (16) in the reverse order of removal.
Illustration 9 g06235002
Position the manifold on the gasket and align with the spring pins. Install bolts (15) and tighten to a torque of 28 7 N m (248 62 lb in) in the clockwise sequence shown above.
Lubricate the bore of tube (7) with the lubricant being sealed.End By:
Install the rear crankcase guard.