SENSOR GP-SPEED 3048880 - Caterpillar

Roading
Check the travel route for adequate overpass clearances. To prevent collision and personal injury.
Always road the machine with the boom over the steering axle. When the boom is over the rear axle, the steering and travel pedal functions are reversed and there is no hydraulic retarding. Travel with the boom over the rear axle should be limited to short distances when dozing and low speed range.
Basic standard machine shipping specifications are listed below for the 206. Basic standard machine shipping specifications are listed below for the 212. Local roading regulations could require the boom to be retracted. Check and obey all local and all traffic regulations.Check all fluid levels and tire air pressures before traveling.Boom Retracting (Two Piece Boom Only)
1. To retract the boom, dig a small trench for the stick to sit in.2. Pull the cotter pins and retainers.3. Carefully drive forward to position the boom into the front two holes.4. Install the retainers and cotter pins.Cab Roading Procedures
Align the boom and upper structure over and with the steering axle wheels in the forward position. Engage the swing lock pin. Push the swing brake pedal down until the detent locks the pedal down. Lock the front attachment after placing into the traveling position. Move the shutoff lever for road travel. Move the lever to lock the blade in the travel position, to prevent accidental blade lowering. Raise the stabilizers up and turn the pads in. Use the retainers to hold stabilizers in the up position.