SENSOR AS-FUEL LEVEL 3382508 - Caterpillar

Personal injury or death could result when towing a disabled machine incorrectly.Block the machine to prevent movement before releasing the brakes. The machine can roll free if it is not blocked.Follow the recommendations below, to properly perform the towing procedure.Serious injury or death could result when incorrectly towing a disabled machine. Use the following instructions for proper towing procedure.While towing the machine without brakes, a vehicle must be attached to each end of the machine being towed to provide sufficient control and braking when moving a disabled machine downhill. This will prevent it from rolling uncontrolled. Uncontrolled motion could cause serious injury or death.
These towing instructions are for moving a disabled machine a short distance, only a few feet at low speed, no faster than 2 km/h (1.2 mph), to a convenient location for repair. These instructions are for emergencies only. Always haul the machine if long distance moving is required.Shielding must be provided on the towing machine, to protect the operator if the tow line or bar should break.Do not allow operator on the machine being towed, unless the operator can control the steering and/or braking.Before towing, make sure the tow line or bar is in good condition and has enough strength for the towing situation involved. Use a towing line or bar with a strength of at least 1.5 times the gross weight of the towing machine, for a disabled machine stuck in mud or when towing on a grade.Keep the tow line angle to a minimum. Do not exceed a 30° angle from the straight ahead position.Quick machine movement could overload the tow line or bar and cause it to break. Gradual and smooth machine movement will work better.Normally, the towing machine should be as large as the disabled machine. Satisfy yourself that the towing machine has enough brake capacity, weight and power, to control both machines for the grade and distance involved.To provide sufficient control and braking when moving a disabled machine downhill, a larger towing machine or additional machines connected to the rear could be required. This will prevent it from rolling uncontrolled.The different situation requirements cannot be given, as minimal towing machine capacity is required on smooth level surfaces to maximum on inclines or poor surface conditions.Consult your Caterpillar dealer for additional towing information for a disabled machine. If the steer system and brake system work and the engine is operable, it is not necessary to disconnect the brake or steer system before towing the machine, items 6 and 7. 1. If the engine is inoperable and there is no steering and brake control, block the drum and rear tires securely to prevent machine movement. Do not remove blocks until tow vehicle has been positioned and tow lines in place. 2. Disconnect the hydraulic hoses leading to the drum drive motor at the propel pump. 3. Cap the ports in the propel pump, then connect the two hoses together to form a closed loop to the drum drive motor. Be sure the