SENSOR AS-TEMPERATURE 3426632 - Caterpillar

Table 1
Required Tools
Description Qty
Stopwatch 1
Illustration 1 g00297292
Start the engine.
Position the machine on level ground.
Increase the hydraulic oil temperature to 55° 5°C (131° 9°F).
Raise a track off the ground. Refer to Illustration 1.
Put a mark on a shoe of the raised track.
Place the machine controls at the following settings: Engine speed dial "10" and AEC switch OFF.
Place the travel speed control switch in HIGH position.
Move the travel lever of the raised track to full travel position.
Measure the time that is required for the raised track to make three complete revolutions. Measure the time that is required in each direction.
Place the travel speed control switch in the LOW position and repeat Steps 8 through 9.
Table 2
313D2 LGP Time For Three Revolutions (time in seconds)
Travel Speed New Rebuild Service Limit
HIGH Forward 21.1 or less 22.8 or less 25.7 or less
Reverse
LOW Forward 33.8 or less 37.4 or less 42.3 or less
Reverse