SENSOR-PRESSURE 3559448 - Caterpillar

Illustration 1 g01044774
Remove one bolt (4). Install Tooling (B) and a suitable lifting device to vibration damper (3) and crankshaft pulley (1). The weight of vibration damper (3) and crankshaft pulley (1) is approximately 57 kg (125 lb).
Remove one bolt (2). Install Tooling (A).
Remove remaining bolts (2). Remove vibration damper (3) and crankshaft pulley (1) from the crankshaft.
Remove bolts (4). Remove spacer (5). Remove vibration damper (3) from crankshaft pulley (1). The weight of vibration damper (3) is approximately 34 kg (75 lb). Installation Procedure Type 1
Table 2
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(5/8 - 18 NF by 7 inch) 1
B 138-7575 Link Bracket 1
C 4C-5592 Anti-Seize Compound 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Thoroughly inspect the viscous damper for signs of leakage or for signs of a dented (damaged) case. Either of these conditions can cause the weight to make contact with the case. This can affect the viscous damper's operation.
Illustration 2 g01044774
Position vibration damper (3) on crankshaft pulley (1). The weight of vibration damper (3) is approximately 34 kg (75 lb).
Install spacer (5) on the vibration damper. Install bolts (4) and tighten the bolts to a torque of 135 20 N m (100 15 lb ft).
Install Tooling (B) and a suitable lifting device on vibration damper (3) and crankshaft pulley (1). The weight of vibration damper (3) and crankshaft pulley (1) is approximately 57 kg (125 lb). Install the vibration damper and the crankshaft pulley on Tooling (A).
Apply Tooling (C) to bolts (2). Install the bolts. Remove Tooling (A) and install the remaining bolts. Tighten the bolts to a torque of 215 40 N m (159 30 lb ft). Removal Procedure Type 2
Table 3
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(5/8 - 18 NF by 7 inch) 1
Illustration 3 g03181887
Remove pulley (1) and the belt. Refer to Belt Tensioner - Remove and Install.
Illustration 4 g03181936
Remove one bolt (2). Install Tooling (A) and a suitable lifting device to vibration damper (4). Remove bolts (2), spacer (3), and vibration damper (4). The weight of vibration damper (4) is approximately 13.7 kg (30.22 lb). Installation Procedure Type 2
Table 4
Required Tools
Tool Part Number Part Description Qty
A - Guide Stud
(5/8 - 18 NF by 7 inch) 1
C 4C-5592 Anti-Seize Compound 1
Illustration 5 g03181936
Install Tooling (A) into the Crankshaft. Position vibration damper (4) onto Tooling (A). The weight of vibration damper (3) is approximately 14 kg (30 lb).
Apply Tooling (C) onto bolts (2). Install spacer (3) and bolts (2).
Illustration 6 g03181887
Install pulley (1). Refer to Belt Tensioner - Remove and Install.