SENSOR GP-GRADE 3628687 - Caterpillar

Oil Pressure Test
Ensure that the engine oil pressure is within the correct operating range before performing any tests on the compression brake. Low engine oil pressure can cause weak braking or no braking at all. High engine oil pressure may cause the compression brake not to operate at all. Refer to Testing and Adjusting, "Engine Oil Pressure - Test" for more information.To properly troubleshoot the compression brake, the technician must know the oil pressure reading at the compression brake housings. The oil pressure reading on the oil pressure gauge in the instrument panel does not provide the same information as the oil pressure reading at the compression brake housings.High oil pressure may prevent the compression brake from shutting off.Oil Pressure Test at Solenoid Valve
Work carefully around an engine that is running. Engine parts that are hot, or parts that are moving, can cause personal injury.
Table 1
Tools Needed    
Part Number     Part Name     Quantity    
149-6111     Oil Pressure Test Kit     1    
Illustration 1 g00527135
(1) Pressure gauge (2) O-ring seals for the solenoid valve (3) Adapter (4) Test body for the control valve (5) Control valve adapter (6) Solenoid valve adapter
Attach pressure gauge (1) to solenoid valve adapter (6) .
Remove the solenoid valve and the three seals from the compression brake housing. Refer to Disassembly and Assembly, "Compression Brake - Disassemble" for more information.
Install three new seals (2). Place the smallest seal in the bottom of the bore for the solenoid. Install the other two seals on solenoid valve adapter (6) .
Illustration 2 g00521296
Typical example (7) Bore
Lubricate the seals with clean engine oil and install the adapter assembly in bore (7) for the solenoid valve. Hand tighten the adapter assembly and then tighten the adapter assembly for an additional 1/4 turn.
Start the engine. Ensure that the compression brake switch is in the OFF position.
Record the oil pressure reading.
Increase the engine speed by 400 rpm.
Repeat Steps 6 and 7 up to the rated engine rpm.
Stop the engine. Install the solenoid valve. Refer to Disassembly and Assembly, "Compression Brake - Assemble" for more information.Compare the oil pressure readings from the solenoid valve to the oil pressure readings from the control valve. Refer to Testing and Adjusting, "Control Valve (Compression Brake) - Test". If the oil pressure at the solenoid valve is higher than the oil pressure at the control valve, continue with Steps 10 through 15.
Start the engine.
Disconnect the wires from each solenoid valve except for the solenoid valve that is being tested in order to check each solenoid valve individually.
Illustration 3 g00521295
Typical example (8) Solenoid armature
Turn the compression brake switch to the ON position. Observe the movement of solenoid armature (8). The solenoid armature should snap down fully. Push down on the solenoid armature in order to verify that the solenoid is fully actuated.If the solenoid valve fully actuates, proceed to Step 14. Otherwise, continue to Step 13.
Check the voltage at the terminals on the solenoid valve. There should be at least ten volts at the