SENSOR GP-SOOT 3902833 - Caterpillar

Introduction
The following instructions explain the procedure to install the 469-1497 Hydraulic Ar-Work Tool .Note: Drain the hydraulic fluid from the hydraulic tank before opening the hydraulic system. Remember to fill the hydraulic tank with hydraulic fluid once the installation is complete.ReferenceTorque Specifications, SENR3130, "Torque Specifications"Safety Section
Illustration 1 g00104545
Attach a "Do Not Operate" warning tag or a similar warning tag to the start switch or to the controls before you service the equipment. These warning tags (Special Instruction, SEHS7332) are available from your Caterpillar dealer.
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury or death can result from sudden work tool movement.Sudden movement of the work tool can cause injury to persons near the work tool.To prevent injury or death, make sure that the area around the work tool is clear of personnel and obstructions before operating the work tool.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Parts Section
Table 1
469-1497 Hydraulic Ar-Work Tool Revision - 00    
Qty    Part Number    Description    Media    
1    418-4771     Auxiliary Hydraulic Boom Lines Gp     GEHS0973    
1    419-1781     Auxiliary Hydraulic Stick Lines Gp     GEHS0974    
1     468-2118     Front Lines Gp     GEHS0970    
1     468-2119     Pilot Lines Gp     GEHS0971    
1     468-3798