SENSOR GP-PRESSURE 4535523 - Caterpillar

warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance, including all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine - Clean
Engine Oil Level Gauge - Calibrate
Engine Storage Procedure - Check
Fuel System - Prime
Heat Exchanger - Inspect
Maintenance Recommendations
Overhaul (Major)
Sea Water Strainer - Clean/Inspect
Zinc Rods - Inspect/Replace
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Walk-Around Inspection
Initial 20 to 40 Service Hours
Belts - Inspect/Adjust/Replace
Every 50 Service Hours or Weekly
Aftercooler Condensate Drain Valve - Inspect/Clean
Sea Water Strainer - Clean/Inspect
Initial 250 Service Hours (or at first oil change)
Engine Valve Lash - Check
Every 7100 L (1875 US gal) of Fuel or 250 Service Hours or 1 Year
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Oil Sample - Obtain
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 14 200 L (3750 US gal) of Fuel or 500 Service Hours
Coolant Sample (Level 1) - Obtain
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Every 28 400 L (7500 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Engine Crankcase Breather - Clean
Engine Mounts - Inspect
Heat Exchanger - Inspect
Turbocharger - Inspect
Every 56 800 L (15 000 US gal) of Fuel or 2000 Service Hours
Alternator - Inspect
Coolant Temperature Regulator - Replace
Crankshaft Vibration Damper - Inspect
Engine Speed/Timing Sensor - Clean/Inspect
Engine Valve Lash - Check
Starting Motor - Inspect
Water Pump - Inspect
Every Year
Coolant Sample (Level 2) - Obtain
Every 340 500 L (90 000 US gal) of Fuel or 10 000 Service Hours
Overhaul (Major)
Every 5 Years
Oil Cooler Core - Check/Clean/Test
Every 6 Years
Aftercooler Core - Replace