SENSOR GP-SOOT 4644920 - Caterpillar

4644920 SENSOR GP-SOOT Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4644920
464-4920
4644920

Weight: 1 pounds 0 kg.

Buy SENSOR GP-SOOT 4644920 Caterpillar genuine, new aftermarket tractor parts with delivery

Related part:

4644920 MONITOR GP-EXH 20R7482 R

Compare Prices: .

As an associate, we earn commssions on qualifying purchases through the links below

Ochoos RNA4920 Heavy Duty Needle Roller Bearing Entity Needle Bearing Without Inner Ring 4644920 size11514040

$110.79

17 Aug 2021

RU: Udith

Ochoos RNA4920 Heavy Duty Needle Roller Bearing Entity Needle Bearing Without Inner Ring 4644920 size11514040
Ochoos Material: Steel || Model number: RNA4920 || Coatings: other || Structure: other

Number on catalog scheme: 3

Caterpillar 4644920 Parts scheme SENSOR GP-SOOT

For full view, you need register

Information:

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8S-2269 Ridge Reamer 1 Start By:
Remove the oil suction pipe. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install" for the correct procedure.
If necessary, remove the balancer. Refer to Disassembly and Assembly, "Balancer - Remove" for the correct procedure.
Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Remove" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Rotate crankshaft until the required connecting rod is at bottom dead center.
Using tooling (A), remove carbon build-up from the top of the cylinder bore.
Illustration 1 g03001196
Typical example
Note: Do not stamp the connecting rod assembly. Stamping or punching the connecting rod assembly could cause the connecting rod to fracture.
The connecting rod and the connecting rod cap should have an etched number in Position (X). The number on the connecting rod and the connecting rod cap must match. Ensure that connecting rod (3) and connecting rod cap (1) are marked for the correct location. If necessary, make a temporary mark on the connecting rod and the connecting rod cap in order to identify the cylinder number and orientation of the assembly.
Remove the bolts (2) and remove connecting rod cap (1) from connecting rod (3).
Rotate crankshaft so that the required piston is at top center position.
Illustration 2 g02998516
Typical example
Carefully push piston (4) and the connecting rod out of the cylinder bore. Lift piston (4) out of the top of the cylinder block. Note: Do not apply force to the fracture split surfaces of the connecting rod as damage may result.
Temporarily install connecting rod cap (1) and bolts (2) to connecting rod (3) when the assembly is out of the engine. Ensure that the etched number on connecting rod cap matches the etched number on connecting rod. Ensure the correct orientation of the connecting rod cap. The locating tab for the upper bearing shell and the lower bearing shell should be on the same side. Tighten bolts (2) to a torque of 20 N m (177 lb in).
Repeat Step 1 through Step 7 in order to remove the remaining pistons and connecting rods. Fracture split connecting rods should not be left without the connecting rod caps installed.