SEPARATOR GP-WATER 1181467 - Caterpillar

Remove Engine Oil Coolers And Cooler Lines (Marine Engine)
START BY:a. remove oil filter base (marine engine) 1. Remove the bolts from elbows (1) and (6). Remove elbow (1), cooler (3) and elbow (6).2. Remove the bolts from body (2) and elbow (5). Remove body (2), tube (4) and elbow (5). 3. Disconnect line (7). Remove bolts (9) from bonnet (8).4. Remove the bolts from the elbow on the front end of cooler (10). Remove the elbow, cooler (10) and bonnet (8). 5. Clean the tube bundles for both the engine oil cooler and marine cooler with a 3.18 mm (.125 in.) diameter rod as shown.Install Engine Oil Coolers And Cooler Lines (Marine Engine)
1. Put clean engine oil or glycerine on the O-ring seals for bonnet (5), elbow (3), tube (8), elbow (6), elbow (9) and on the bores of cooler (2), body (1), elbow (4) and cooler (7).2. Install bonnet (5), cooler (2) and elbow (3) on the side of the engine block. Connect the water line to bonnet (5).3. Install body (1), tube (8) and elbow (4) below the engine oil cooler.4. Install marine cooler (7), elbow (6) and elbow (9).END BY:a. install oil filter base (marine engine)