SERVICE GP-IMPLEMENT 2115560 - Caterpillar

Removal Procedure
Illustration 1 g00521987
Illustration 2 g00580906
Use a screwdriver in order to remove caps (2) from pull handle assembly (1).
Illustration 3 g00580901
Remove bolts (3) in order to remove pull handle assembly (1).
Illustration 4 g00580933
Loosen set screw (5) in order to remove knob (4) from the door handle.
Illustration 5 g00580935
Use a screwdriver to pry rocker switch assembly (6) from panel assembly (7).
Illustration 6 g00580937
Disconnect harness assembly (8) from rocker switch assembly (6).
Illustration 7 g00580942Note: Mark all of the bolts, the screws and the washers for installation purposes.
Remove bolts (11) in order to remove door stop (10) from panel assembly (7).
Remove button head screws (12) from panel assembly (7).
Remove truss head screws (9) in order to remove panel assembly (7). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 4C-9613 Silicone Sealant 1
Illustration 8 g00580942
Verify that all of the components of panel assembly (7) are clean and free of foreign material prior to installation.
Inspect all of the components for wear and replace the components, if necessary. Note: Apply Tooling (A) to the back of panel assembly (7) prior to installation.
Use truss head screws (9) in order to install panel assembly (7), as shown.
Install button head screws (12) into panel assembly (7).
Use bolts (11) in order to install door stop (10) to panel assembly (7).
Illustration 9 g00580937
Connect harness assembly (8) to rocker switch assembly (6).
Illustration 10 g00580935
Press rocker switch assembly (6) into panel assembly (7).
Illustration 11 g00580933
Position knob (4) onto the door handle, as shown. Tighten set screw (5).
Illustration 12 g00580901
Use bolts (3) in order to install pull handle assembly (1).
Illustration 13 g00580906
Install caps (2) onto pull handle assembly (1).