SERVICE METER GROUP 3S3581 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     1P-0510     Driver Group     1    Note: Use 8T-0447 Dial Calipers to measure the dimensions in the following procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Illustration 1 g00627067
If the bearing was removed from housing (4), Use Tooling (A) and install the bearing in the housing. The inside diameter of the bearing must be 24.993 0.033 mm (0.9840 0.0013 inch).
Place pinion (3) in position in housing (4). Install thrust washer (2) and the bolts that hold the thrust washer in place.
Place coupling (1) in position on pinion (3) .End By: Install the governor drive. Refer to Disassembly and Assembly, "Governor Drive - Install".