SERVICE G-FUEL 9F2393 - Caterpillar

Removal Procedure
Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly , " Hydraulic System Pressure - Release". Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Keep all parts clean from contaminants.Contamination of the hydraulic system with foreign material will reduce the service life of the hydraulic system components.To prevent contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. Cover any disassembled components and clean them properly before assembly.Clean the hydraulic system properly after any major component exchange or especially after a component failure, to remove any contamination.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01443048
Remove lever (2). Remove knobs (4) and armrest (1). Remove bolts (5) and (6). Remove covers (3) and (7).
Illustration 2 g01443051
Remove bolts (8) and position bracket (9) to the side.
Illustration 3 g01443054
Remove knob (12). Remove bolts (11) and (13). remove panels (10) and (14).
Illustration 4 g01443055
Remove bolts (15) and cover (16). Remove bolts (18) and cover (17).
Illustration 5 g01443056
Remove screws (19) and place lever (20) to the side.
Illustration 6 g01443057
Remove bolts (21) and (23). Remove bracket (22).
Illustration 7 g01443058
Remove screws (24) and (25).
Illustration 8 g01443059
Cut cable straps (28) and (31). Disconnect harness assembly (30). Remove bolts (26) and (29). Remove bracket (27).
Illustration 9 g01443060
Disconnect hose assemblies (32) and (33).
Illustration 10 g01443062
Disconnect harness assembly (36). Disconnect hose assemblies (37) and (38). Remove bolts (35) and remove STIC control (34).