SET-BEVEL GEAR 2652109 - Caterpillar

Illustration 1 g01616336
Right side view
Typical example
Illustration 2 g02557456
Front view
Typical example
Table 1
Specification for 115-7860 Engine Oil Lines Gp, 202-2657 Engine Oil Lines Gp, and 262-0338 Engine Oil Lines Gp
Item Qty Part Specification Description
- - 0S-1594 Bolt Use the following tightening sequence for the clamp bolts:
1. Snugly tighten the clamp assembly (3) to the tube (4).
2. Tighten two bolts (2) of the clamp assembly to the elbow (9) to 47 9 N m (35 7 lb ft).
3. Tighten two bolts (1) of the clamp assembly to the tube (4) to 47 9 N m (35 7 lb ft).
- - 0S-1571 Bolt
- - - The cooling jet sequence valves must start to open at a pressure difference of 130 30 kPa (19 4 psi).
The cooling jet sequence valves must be fully open at a pressure difference of 200 30 kPa (29 4 psi).
5 2 6B-9202 Spring Length under test force is 68.3 mm (2.69 inch).
Test force is 85 to 100 N (19 to 22 lb).
Free length after test is 112.7 mm (4.44 inch).
6 1 2W-1635 Spring Length under test force is 102.0 mm (4.02 inch).
Test force is 518 26 N (116 6 lb).
Free length after test is 143.4 mm (5.65 inch).
The oil cooler bypass valve must open with a pressure difference of 180 20 kPa (26 3 psi).
7 6 109-2332 O-Ring Seal Lubricate the bore lightly with the clean engine oil.
8 1 2W-1053 Plug Torque to 100 15 N m (74 11 lb ft).