SET-RIVET-ROLL 6F6946 - Caterpillar

Install O-ring seals (33) onto solenoid (12).
Illustration 7 g03435645
Install O-ring seals (32) onto solenoid (9).
Illustration 8 g03435456
Install O-ring seals (31) onto check valve (10).
Illustration 9 g03435437
Install O-ring seals (30) onto check valve (7).
Illustration 10 g03434961
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install cover (29). Install bolts (28). Tighten bolts (28) to a torque of 12 3 N m (106 27 lb in).
Illustration 11 g01361658
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spool (27). Install plug (26). Install retainer (25). Install spring (24). Install retainer (23). Install cover (22). Install bolts (21). Tighten bolts (21) to a torque of 12 3 N m (106 27 lb in).
Illustration 12 g01361643
Install pistons (20).
Illustration 13 g01361634
Install plug (19). Install spool (18). Install spring (17). Install ball (16). Install spring (15). Install plug (14). Tighten plug (14) to a torque of 5 1 N m (44 9 lb in).
Illustration 14 g03434232
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install plug (13). Tighten plug (13) to a torque of 70 7 N m (52 5 lb ft)Install solenoid (12). Tighten solenoid (12) to a torque of 5.5 1.5 N m (49 13 lb in). Install bolt (11). Tighten bolt (11) to a torque of 12 3 N m (106 27 lb in). Install check valve (9). Tighten check valve (9) to a torque of 80 15 N m (59 11 lb ft). Install solenoid (10). Tighten solenoid (10) to a torque of 5.5 1.5 N m (49 13 lb in). Install bolt (8). Tighten bolt (8) to a torque of 12 3 N m (106 27 lb in). Install check valve (7). Tighten check valve (7) to a torque of 80 15 N m (59 11 lb ft). Install plug (6).
Illustration 15 g03434219
Install seal (5). Install control valve (4).
Repeat Step 6 through Step 15 for the remaining control valves.
Install seal (3). Install cover (2).
Illustration 16 g03434195
Install new nuts (1). Tighten nuts (1) in a crisscross pattern to a torque of 25 2.5 N m (221.3 22.1 lb in). Ensure that each nut (1) remains torqued to 25 2.5 N m (221.3 22.1 lb in). Note: Do not reuse nuts that have been torque turned. Replace nuts (1) when servicing the bank valve.
Tighten each nut (1) by an additional 90° 10° in the opposite crisscross pattern. End By:
Install the bank valves.