SFWR GP-A4006 3285202 - Caterpillar

Blade Lift Cylinder Sockets
Adjust - Replace if Necessary
1. Park the machine on level ground, position the blade 90° to the frame, lower the blade to the ground and apply a slight down pressure. 2. There are two 0.51 mm (.020 inch) shims on each side of each joint.3. As wear increases in the joint, shims can be removed to reduce the clearance.To Adjust:
1. Remove the bolts from the cap. Remove the cap. 2. Remove one shim from either side of the joint to reduce the clearance.If two shims need to be removed, remove one from each side of the joint. 3. When an insert needs to be replaced, install new inserts on each side of the joint.4. Install the cap and bolts.Centershift Cylinder Sockets
Adjust - Replace if Necessary
1. Park the machine on level ground, position the blade 90° to the frame. Lower the blade to the ground. Apply a slight down pressure. 2. There are two 0.51 mm (.020 inch) shims on each side of each joint.3. As wear increases in the joint, shims can be removed to reduce the clearance.To Adjust:
1. Remove the bolts from the cap. Remove the cap. 2. Remove one shim from either side of the joint to reduce the clearance.If two shims need to be removed, remove one from each side of the joint.3. When an insert needs to be replaced, install new inserts on each side of the joint. 4. Install the cap and bolts.Seat Belts
Inspect - Replace if Necessary
Always check the condition of the seat belt and mounting hardware before operating the machine.Replace the seat belt at least once every three years, regardless of appearance. A date label, to determine the age of the belt, is sewn onto each belt.
Inspect for worn or frayed webbing.Check for worn or damaged buckle or anticreep slide on each half of the belt. Replace the belt, buckle or slides if they are worn or damaged.Inspect the belt mounting hardware. Replace any damaged or worn hardware. Keep the mounting bolts tight. If the bolt and nut that holds the two parts of the seat belt mounting hooks together are not correctly installed, the hooks can separate. This will allow the seat belt to separate from its mounting.Inspect the hooks of each half of the belt to make certain the bolt and nut are correctly installed.If the bolt and nut are not correctly installed, remove them. Install a new bolt and nut.Adjust Seat Belt
Adjust both ends of the belt. The belt should be snug but comfortable.For adjustment procedures, see topic "Seat Adjustment" in the "Operator's Compartment" section of the operator's guide.Windshield Wipers and Washer
Inspect Wipers - Fill Washer
1. Inspect the windshield wiper blades. Replace them if they are worn, damaged or if streaking occurs.
When operating in freezing temperatures, use any commercially available nonfreezing window washer fluid.
2. Fill the windshield washer bottle.Ether Starting Aid
Change Ether Cylinder
Ether is poisonous and flammable.Breathing ether vapors or repeated contact of ether with skin can cause personal injury.Use ether only in well ventilated