SFWR GP-A5011 3744751 - Caterpillar

Start By:
Remove valve mechanism cover.Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 487-3136 Rocker Shaft Removal and Installation Tool 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g06044402
Remove clip (1).
Illustration 2 g06113004
Install Tooling (A) to and attach a suitable lifting device to rocker arm assembly (2). Rocker arm assembly (2) weighs approximately 13 kg (29 lb).
Illustration 3 g06044952
Loosen bolts (4) and remove bolts (3). Use Tooling (A) and a suitable lifting device to remove rocker arm assembly (2). The weight of rocker arm assembly (2) is approximately 37 kg (81 lb). Remove valve blocks (5).Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install rocker arm assembly (2) in the reverse order of removal.
Illustration 4 g06045630
Tighten bolts (3) to a torque of 25 N m (221 lb in) using the following tightening sequence. Then, tighten bolts (3) to a torque of 60 N m (44 lb ft) using the same tightening sequence. Next, tighten bolts (3) to a torque of 80 N m (59 lb ft) using the same tightening sequence. Finally, tighten bolts (3) an extra 60 degrees.
Adjust the valve lash of the rocker arms. Refer to Test and Adjust, "Engine Valve Lash - Inspect/Adjust" for the correct procedure.