SFWR GP-A2000 4587100 - Caterpillar

2 Remove the old seal (1) with the 5P7414 Seal Pick (2) or a similar tool.3 Use screwdriver (3) as a scraper to clean the seal pocket.4 Wash the coil and seal socket with a general purpose solvent and use air under pressure to make the part completely dry.5 Use alcohol or 8M8060 Primer to clean any oil and dirt from the seal pocket. Before the next step is started, be sure the seal pocket and coil body are dry; do not use air pressure.6 Put RTV adhesive (4) in the seal pocket and use spreader (5) to make it smooth and even. This operation and the next step must be complete in from three to fifteen minutes.7 Remove seal (6) from the package. Do not let the red sponge rubber come into contact with the fingers or get dirt or oil on it.8 Install seal (6) in the seal pocket with the red rubber against the adhesive.9 Push seal (6) into the seal pocket all around with seal pick (2) as shown.10 Do not assemble the compressor at this time. Let the adhesive cure for twenty-four hours before the compressor is assembled.