SFWR GP-A1000 4789999 - Caterpillar

Illustration 41 g00827549
Click on the "Yes" button to change the Product ID or click on the "No" button to cancel the change.If you enter an invalid "Product ID", the ET will display the following message:
Illustration 42 g00827550
Set the Time and the Date
It is necessary to set the correct time and the date for the Machine Security System. Use the following procedure to set the time and the date.
Connect the ET to the service connector via the communication adapter.
Place the Master Access Level Key into the key start switch and turn the key to the ON position.
Start the ET.
Click on the "Connect" icon in the menu bar of the ET.
Once the ET has established communications with the MSS ECM, select the "ECM date/time" option from the "Service" menu. This will cause the ET to display the following screen.
Illustration 43 g00827585
Press the "Change" button.
Illustration 44 g00827586
Enter the correct time and the date and press the "OK" button. Then, the ET will display the following message.
Illustration 45 g00827587
Click on the "Yes" button in order to change the date/time clock or click on the "No" button in order to cancel the change.
Perform the ""Operational Check"".Operational Check
Place a valid electronic key in the key start switch.
Turn the electronic key to the ON position until the green LED indicator turns ON.
Turn the key to the START position. The machine should start.
Turn the key to the OFF position.
Disconnect the grounded battery cable from the battery.
Reassemble all of the remaining parts and covers.
Reconnect the grounded battery cable to the battery.
Attach Special Instruction, RMHS10002, "Operation of the Machine Security System" to the machine's Operation and Maintenance Manual with the double side tape that is provided.
Attach the Machine Security System film on the door of the machine or on the ROPS near the mounting and dismounting location of the operator.Troubleshooting (All Machines)
The machine fails to start
Indicator light does not turn on
Verify that all connections are tight.Check the indicator light.Indicator light remains red
The indicator is red for five seconds after attempting to start the machine. This indicates one of the following problems:
The key in the key start switch is not authorized for that machine. Refer to Service Manual, RENR2462, "Machine Security System (MSS)", "Key - Program".
The Remote Key Reader is not working properly. Check the resistance of the wiring for the Remote Key Reader. Also, check the resistance of the Remote Key Reader.Indicator light becomes green but the engine will not start
The indicator light displays a green light for 30 seconds after you attempt to start the machine. This indicates that the Machine Security System has recognized a valid key for the machine. Ensure that all of the standard starting requirements for the machine have been met. Examples of the starting requirements include: interlocks in the operator seat, hydraulic interlocks, the machine is in the correct gear and fuel level. Once you have verified that all of the starting requirements have been met for the machine, then check the wiring on the output circuits of the ECM for the MSS.Final Assembly
Follow operating procedures to