SFWR GP-A5007 5150008 - Caterpillar

Controls
Cleaning And Lubrication
1 - Clean and apply the grease with a bush along the steering chain. 2 - Lubricate the accelerator and engine stop cables. 3 - Apply grease with a brush and lubricate the control cables on the engine.Batteries
Check Electrolyte Level
Do not smoke when observing the battery electrolyte level. Batteries give off fumes that can explode.Electrolyte is an acid and can cause personal injury if it contacts the skin or eyes.
1 - Unlatch the battery compartment covers. 2 - Clean the top of the batteries. Coat all posts with petroleum jelly.Low Maintenance Batteries with Refillable Cells Only
3 - Remove each fill cap. Inspect the electrolyte level. 4 - If necessary, add distilled water to bring the electrolyte level to the bottom of the fill opening.At proper charge rate in a temperate climate, a battery will not require more than 30 cc (1 ounce) of water per cell per week. 5 - Install all fill caps. 6 - Close and latch the battery compartment covers.Cooler
Cleaning the Cooling Fins
Pressure air can cause personal injury.When using pressure air for cleaning, wear a protective face shield, protective clothing and protective shoes.The maximum air pressure must be below 205 kPa (30 psi) for cleaning purposes.
Do not clean any cooling element by bumping or tapping.
Remove the cover to reach the cooling fans. Clean the cylinder head fins and the oil cooler fins by scraping with a metallic brush and with compressed air or with a steam cleaner.Mobile Eccentric Mass
Lubrication
Grease the mobile eccentric mass in the front drum.