SFWR GP-A4032 5163808 - Caterpillar

Parking Brake Pivot Fitting
Oil pivot points
Apply one to two drops of oil to the pivot points on the parking brake lever.Brake master cylinder
Check fluid level
1. Remove the plastic plug from front face of console. 2. Reach into the console and remove the fill plug from top of master brake cylinder.3. Fluid should lie approximately 5 mm (1/4 in.) from the top edge of master cylinder reservoir.4. If low, add clean fluid, replace fill cap and plug in console.Hydraulic Reservoir
Check oil level
1. Remove the cap on the hydraulic reservoir and observe the hydraulic oil level.2. Hydraulic oil should be at the FULL (1) mark on the reservoir. If oil level is below the ADD (2) mark.Differential
Check lube level.
1. Remove the fill/check plug located in the center of the differential case.2. Gear lube should be at this level.3. If gear lube is low, add gear lube to raise to this level.4. Replace fill/check plug.