AVSPARE.COM
parts catalog

SHAFT 0005383 - Caterpillar



0005383 SHAFT Caterpillar parts SHAFT
Rating:
11
Alternative (cross code) number:
CA0005383
000-5383
0005383
Caterpillar 0005383 SHAFT
Weight: 0.60 pounds 0 kg.

Buy SHAFT 0005383 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


Once the system is placed in automatic mode, blade movement may occur.Ensure that all personnel are clear of the blade before you place the system in automatic mode.Personal injury or death from crushing could occur.
When the blade movement stops, switch the system back into manual mode.Note: Do Not Move The Blade.
Place blocks under the blade before checking blade level.
Illustration 1 g01097310
Use a level in order to check that the cutting edge of the blade is level.
If the blade is not level, determine if the left side of the blade is high or low.
Enter the "Configuration" menu.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch until "Linked Elevation Adjustment" is highlighted on the display.
Illustration 2 g00995301
Press the OK/right reset button in order to enter the "Linked Elevation Adjustment" menu. A screen similar to Illustration 2 appears.Note: The number is always zero when you enter this screen. The maximum value that may be added to the screen is plus or minus 0.030 m (0.1 ft)
Enter a positive value in order to lift the left side of the blade. Enter a negative value in order to lower the left side of the blade.Use the steps that are outlined below:
Press the cursor scroll switch in order to move the cursor to the right. Continue to move the cursor until the digit that you want to change is highlighted.
After the digit in (Step 11.a) is highlighted, do one of the following.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch UP in order to increase the elevation offset adjustment to the required value.
Toggle either the right mast elevation/menu scroll switchswitch or the left mast elevation/menu scroll switch switch DOWN in order to decrease the elevation offset adjustment to the required value.
After the required value in (Step 11.b) has been entered, do one of the following.
Press the OK/right reset button in order to save the changes and exit to the "Configuration" menu.
Press the ESC/left reset button in order to cancel the changes and exit to the "Configuration" menu.


Parts shaft Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.