SHAFT 0994105 - Caterpillar

Illustration 1 g01042827
Schematic of the body position sensor
This diagnostic code is associated with the body position sensor. This diagnostic code is recorded when the Power Train/Chassis Electronic Control Module (ECM) reads the voltage of the sensor as being below normal. The voltage of the signal wire is below normal and/or shorted to ground. The possible causes of this diagnostic code are listed here:
The sensor has failed.
The signal circuit in the machine harness is shorted to ground.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1175 FMI 04 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:The body snub function for the hoist system does not operate properly when the body is lowered. The gear of the machine is limited. The gear is limited to the current setting for the gear limit function. The hoist system will operate properly after the diagnostic code has been corrected.Test Step 1. CHECK THE SENSOR.
Turn the battery disconnect switch and the key start switch to the ON position.
Observe the status of the diagnostic code. Then disconnect the machine harness from the sensor. Expected Result:If the sensor is not the cause of the diagnostic code, the diagnostic code remains active. If the sensor has failed, the diagnostic code is no longer active.Results:
OK - The diagnostic code is active. The sensor is not causing the diagnostic code. The machine harness or the ECM may have failed. Proceed to Test Step 2.
NOT OK - This diagnostic code is no longer active. The machine harness is correct and the ECM is operating properly. The sensor has failed.Repair: Replace the sensor.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT FOR A SHORT TO GROUND.
The sensor remains disconnected from the machine harness.
Turn the key start switch and the battery disconnect switch to the OFF position.
Disconnect the machine harness from the ECM.
At the machine harness connector for the ECM, measure the resistance between the signal contact and frame ground. Expected Result:The resistance is greater than 5 ohms.Results:
OK - The resistance is greater than 5 ohms. The harness circuit resistance is correct. Proceed to Test Step 3.
NOT OK - Resistance is less than 5 ohms. The machine harness has failed.Repair: There is a short between frame ground and the signal circuit in the machine harness. Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect the contacts of the harness connectors and clean the harness connectors.
Reconnect all the harness connectors.
Turn the battery disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 1175 FMI 04. Expected Result:The CID 1175 FMI 04 is active. Results:
YES - The CID 1175 FMI 04 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely