SHAFT GP-DRIVE 1168129 - Caterpillar

Illustration 20 g01322279
(24) 164-1342 Special Bolt (25) 164-1343 Thrust Washer (26) 164-1344 Thrust Washer (27) 164-1345 Bearing (37) 229-0298 Linkage Assembly
Install the upper window assembly (39) into the window frame (3). Use bolt (24), washer (25), washer (26), and bearing (27) in order to fasten the window assembly (39) onto the linkage assembly (37). Refer to Illustration 19 and Illustration 20. Installing the Side Glass Panels
Illustration 21 g01322489
Window and channel on the left-hand side (1) 205-9586 Channel (5) 205-9609 Glass (6) 223-2030 Latch As (D) 342 mm (13.5 inch) (E) 12.5 mm (0.50 inch)
Illustration 22 g01322354
(1) 205-9586 Channel (F) Grab handle on the left-hand side
Cut a notch in channel (1) for grab handle (F) on the left-hand side. Refer to Illustration 21 and Illustration 22 for the left-hand side example.
Cut a notch in channel (2) for the grab handle on the right-hand side. Refer to Illustration 21 and Illustration 22 for the left-hand side example.
Illustration 23 g01315361
(H) 8 1 mm (0.32 0.04 inch)
Remove 8 1 mm (0.32 0.04 inch) from the bottom of channel (1) and the bottom of channel (2). Refer to Illustration 23.
Illustration 24 g01322278
(1) 205-9586 Channel (F) Grab handle on the left-hand side (J) 2 mm (0.08 inch)
Tack weld channel (1) into position on the left-hand side. Refer to Illustration 24 for the left-hand side example. Note: All welding and fabrication on the rollover protective structure ROPS must be performed by a ROPS certified welder. All welds must be applied in the same manner as an enclosed rollover protective structure EROPS and in the same places as an EROPS. Special care must be taken in order to avoid creating a hole in the ROPS tube. Any hole that is created in the ROPS tube may void the ROPS/FOPS certification. Refer to Special Instruction, SEHS6929, "Inspection, Maintenance, and Repair of Rollover Protective Structures (ROPS) and Attachment Installation Guidelines" for additional information for welding on the ROPS.
Tack weld channel (2) into position on the right-hand side. Refer to Illustration 24 for the left-hand