SHAFT-REVERSE 1212537 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    
B     1U-9200     Lever Puller Hoist     1    
C     123-8527     Bearing Puller     1    
9U-6800 Nut     1    
8M-9012 Plate     1    
4C-6504 Puller Rod     1    
124-4641 Sleeve     1    
346-5029 Double Acting Cylinder     1    
350-7768 Electric Hydraulic Pump Gp (115V)     1    
350-7769 Electric Hydraulic Pump Gp (230V)     1    
D     123-8527     Bearing Puller     1    
9U-6702 Puller Stud     1    
9U-6800 Nut     1    
8M-9012 Plate     1    
346-5029 Double Acting Cylinder     1    
350-7768 Electric Hydraulic Pump Gp (115V)     1    
350-7769 Electric Hydraulic Pump Gp (230V)     1    Start By:
Remove the track roller frames.
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Illustration 1 g00823029
Attach Tooling (A) and a suitable lifting device to pivot shaft (1). The weight of pivot shaft (1) is approximately 551 kg (1215 lb).
Attach Tooling (B) to the bottom link bracket of Tooling (A). Attach the other end of Tooling (B) to a stationary object.
Illustration 2 g00826475
Use care when you slide pivot shaft (1) from the machine. Attach another suitable lifting device to pivot shaft (1) for balance during the removal.
Illustration 3 g01129754
Use Tooling (C) in order to remove pivot shaft bearings (2) from main frame (3) .Installation Procedure
Illustration 4 g00821968
Illustration 5 g01129760
Use Tooling (D) to install pivot shaft bearings (2) into main frame (3) .
Illustration 6 g00826475
Attach a suitable lifting device to pivot shaft (1). The weight of pivot shaft (1) is approximately 551 kg (1215 lb). Install pivot shaft (1) into the main frame. Slide pivot shaft (1) into the main frame until pivot shaft (1) extends equally on both sides.End By: Install the track roller frames.