SHAFT 1303359 - Caterpillar

With the direction switch in the forward position, a current (%) will appearat the bottom of the screen. Use the increment and decrement buttons belowthe current display to adjust the current value to match that in Table3 of this procedure for the machine and clutch that is being adjusted.When the desired calibration value is displayed, move the direction switchto the neutral position.
A dialog box will appear after the calibrationof the clutch is complete. The dialog box displays the selected calibrationsand the status. After viewing the status, select the "Continue"button. The Electronic Technician will display the instructions for thecalibration of the next clutch. Continue this procedure to adjust the calibrationvalue for every clutch. The entire calibration procedure will end if the"Cancel" button is pressed.
To exit the calibration, select the "File" menuand then select "Exit".
Note: The transmission clutch fill calibrationshould be performed after adjusting the engagement calibration values.Perform the "Fill Time for the Transmission Clutch (Electronic Technician)? Calibrate" procedure as described below.Fill Time for the TransmissionClutch (Electronic Technician) - CalibrateReference: Testing and Adjusting,824G Series II Wheel Tractor, 825G Series II Soil Compactor and 826G SeriesII Landfill Compactor Power Train, RENR6028 " Fill Time for the TransmissionClutch (Electronic Technician) - Calibrate
Select the "Service" menu in order to begin the calibration procedure.Then select "Calibrations". A second menu will be displayed. Select "TransmissionFill Calibration" from the second menu.
The next screen is the initial calibration screen. Once "TransmissionFill Calibration" has been selected, the screen displays the incrementalinstructions for calibration. The top display area displays status parametersthat are monitored during the calibration. The middle display area displaysinformation about the status of the calibration. The bottom display areadisplays incremental instructions for the calibration. The step that currentlyneeds to be carried out is in bold text. All other steps are displayedin gray text.
Press the "Next>" button in order to start the calibration. The "Next>"button is disabled, until the current step has been successfully completed.A check will be placed in the box that is left of the step, after the currentstep is complete. After the successful completion of a step, press the"Next>" button in order to begin the following step. Continue this processin order to complete the calibration procedure.
The calibration procedure continues until the ECM determines that oneof the steps is not met. The middle display area will display a messagein order to alert you of the error. You can correct the error that is describedin the middle display area or you can cancel the calibration by pressingthe "Cancel" button. The Electronic Technician will display a message inthe middle display area in order to alert you of the problem.
After correcting any problems that may occur, the calibration will proceed.After a brief initialization, each clutch is calibrated in sequence withoutany input from the user. The middle display area will inform the user ofthe progress of the calibration. The calibration of each clutch is approximately90 seconds.
If some of the clutches reach a limit during the calibration, the ECMwill make a log. The ECM will then move to the next clutch.