SHAFT GP-HITCH DRIVE 1346559 - Caterpillar

Failure to properly service the batteries may cause peronal injury.Prevent sparks near the batteries. They could cause vapors to explode. Do not allow the jump start cable ends to contact each other or the machine.Do not smoke when checking battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear eye protection when starting a machine with jump start cables.Improper jump start procedures can cause an explosion resulting in personal injury.Always connect the battery positive (+) to battery positive (+) and the battery negative (-) to battery negative (-).Jump start only with an energy source with the same voltage as the stalled machine.Turn off all lights and accessories on the stalled machine. Otherwise, they will operate when the energy source is connected.
When starting from another machine, make sure that the machines do not touch. This could prevent damage to engine bearings and electrical circuits.Turn on (close) the battery disconnect switch prior to the boost connection to prevent damage to electrical components on the stalled machine.Severely discharged maintenance free batteries do not fully recharge from the alternator after jump starting. The batteries must be charged to proper voltage with a battery charger. Many batteries thought to be unusable are still rechargeable.This machine has a 12 volt starting system. Use only the same voltage for jump starting. Use of a higher voltage damages the electrical system.Refer to Special Instruction, Battery Test Procedure, SEHS7633, available from your Caterpillar dealer, for complete testing and charging information.
Use of Jump Start Cables
When the auxiliary starting receptacles are not available, use the following procedure.
Determine the reason that the engine will not crank. Refer to Special Instruction, SEHS7768 on the use of 6V-2150 Starting Charging Analyzer Group. The procedure is applicable even if the machine does not have a diagnostic connector.
On the stalled machine, place the propel control lever in the STOP position. Engage the parking brake. Move the vibration switch to the OFF position. Move the water spray switch to the OFF position.
Turn the engine start switch key to the OFF position on the stalled machine. Turn off all accessories.
Turn on the battery disconnect switch on a stalled machine.
Move the boost machine so that the cables can reach the stalled machine. DO NOT ALLOW THE MACHINES TO CONTACT EACH OTHER.
Stop the engine on the boost machine. If you are using an auxiliary power source, turn off the charging system.
Check the battery caps for correct placement and for correct tightness. Make these checks on both machines. Make sure that the batteries in the stalled machine are not frozen. Check the batteries for low electrolyte.
Illustration 1 g00573050
Connect the positive jump start cable to the positive jump start stud (1). The positive jump start stud is located behind the access door on the left side of the machine.Do not allow positive cable clamps to contact any metal except for battery terminals.
Connect the other end of the positive jump start cable to the positive terminal of the boost source. Note: Some machines may