SHAFT-INPUT 1394633 - Caterpillar

Joystick Switch Support
The function of joystick switch support is to utilize machine Work Tool joystick switches to interact with Cat Grade Control.
Illustration 1 g02463138
Instructional film located inside of cab
Illustration 2 g02400096
(1) On/off push button
(2) On/off push button
(3) PWM "Thumb" position
(4) Trigger
(5) Trigger
(6) PWM "Thumb" position
(7) On/off push button
(8) On/off push button The following list is basic information about the trigger (4):
Press and hold trigger to enable Cat Grade Control mode of switches.
Inputs (2), (3), (6), and (7) are used for Cat Grade Control when trigger (4) is pressed and held.
If trigger (4) is pressed while another input is engaged, trigger (4) is ignored and work tool function continues.
If trigger (4) is released while another input is engaged, Cat Grade Control function stops and input must return to neutral before system will perform work tool function.Adjusting Target Depth
Perform the following procedure to adjust the target depth:
Hold trigger (4).
Illustration 3 g02400736
Roll thumb (3) up or down to increment or decrement target depth. While adjusting depth, target depth is shown on the display. Refer to Illustration 3.
Release thumb (3).
Release trigger (4). Adjusting Target Slope
Perform the following procedure to adjust the target slope:
Hold trigger (4).
Illustration 4 g02400979
Roll thumb (6) up or down to increment or decrement target slope. While adjusting slope, target slope is shown on the display. Refer to Illustration 4.
Release thumb (6).
Release trigger (4). Set Bench Mark
Perform the following procedure to set bench mark:
Hold trigger (4).
Press and release button (7) to set bench mark. The icon will update to indicate bench mark set if bench mark not previously set.
Release trigger (4). Clear Bench Mark
Perform the following procedure to clear bench mark:
Hold trigger (4).
Press and hold button (7) to clear bench mark. The display will reflect new bench status.
Release button (7).
Release trigger (4). Touch Point
Note: Available if laser not detected or not previously accepted.Perform the following procedure to touch point:
Place bucket on an arbitrary reference location.
Hold trigger (4).
Press and release button (2) to define reference elevation. The display will indicate touch point initiated and provide instructions.
Release trigger (4).
Move machine and return bucket to same reference location as in Step 1.
Hold trigger (4).
Press and release button (2) to update based on reference location. The display will return to normal once touch point process completed.Accept Laser
Note: Available when laser strike detected.Perform the following procedure to accept laser:
Hold trigger (4).
Press and release button (2) to accept laser. The display will indicate laser accepted The icon on the display updates for time period and RH light bar indicates valid strikes detected. The display will indicate laser accepted.
Release trigger (4).