SHAFT 1401321 - Caterpillar

Remove and Uninstall previous version of CATNDM
Illustration 23 g06348844
In Control panel select Programs (37) to uninstall CATNDM
Illustration 24 g06348850
Select Uninstall. (38).
Select CATNDM. Devices Manager. (39).
Illustration 25 g06348859
After uninstalling the CATNDM application, delete all NDM configuration files.
Go to C:\Users\user name directory and delete all CATNDM files as shown below.
Delete the files (40)"NDM", (41)"NDMLock" and (42)"ndm.sqlite" if present.To install correct version of CAT NDM
Illustration 26 g06345491
To install CATNDM 2.20.1, double-click CATNDMsetup.V2.20.1 .
Illustration 27 g06348860
When application runs press Next (43) Using the Networking Devices Manager Setup Wizard.
Illustration 28 g06348861
Installing using CATNDM install wizard. (44).
Illustration 29 g06342037
" Please wait " while setup installs.
Illustration 30 g06348862
On completion of installing select Finish (45) to exit the setup wizard.
Illustration 31 g06348865
After installing the CATNDM 2.20.1, the radio should appear CATNDM application (46) Check for correct firmware at (47).
Illustration 32 g06348866
The default security for the radio units is WEP (48) using a 128bit (26 hex digits) key.
The radio units (onboard and offboard) can be configured to WPA/WPA2-PSK if required.
Illustration 33 g06348870WPA/WPA2-PSK (49) Security option now available.
Illustration 34 g06348871Pre shared Key is the same for all radios, da5ca7da5ca7da5ca7da5ca777 (50).
If changing wireless security settings ensure that all radios are configured and have the same security settings. A failure to have all settings the same will cause a loss of communication between radio's.
In the event of any replacement radio's being fitted ensure that all security settings are set the same, to enable communication between all radio's.