SHAFT 1562824 - Caterpillar

Installation
Install the 4 Bolts in the Mode Indicator Lights base.
Remove the cover receptacle over the RJ-C2 connector.
Untie the RJ-C2 connector of the harness.
Connect the RJ-C2 and RL-C1 or RJ-C3 and LL-C1 connectors to the Mode Indicator Lights.
Illustration 1 g06153849
Install each light tower to the ROPS with four 8T-4137 Bolts and four 8T-4121 Hard Washers. Install three 4P-7581 Clips to secure the wiring harnesses. The clips are installed under both forward mounting bolts and under the inboard rear mounting bolt.
Route the light tower wiring across the top of the ROPS, to the right, then down the inside edge of the right pillar.
Connect all lighting harness connectors to the cab harness.Operator Console Antenna Relocation for Conceal Mode
Illustration 2 g06320666
Left rear view of the ROPS
(1) Concealed operation antenna location with RC indicators removed.
(2) Preferred antenna location with RC indicators installed.Instructions for moving the Operator Console Antenna from on top of the indicator lights to the concealed mode location on the side of the cab. To ensure optimal range and performance, the Preferred antenna location is on top of the RC Indicators. When the machine is running in a concealed type operation, the operator console antenna may be relocated to a lower position.
Illustration 3 g06320667
Top of left side RC mode indicators
(3) Nut from the 347-6377 Connector Receptacle As
Remove the nut from the 347-6377 Connector Receptacle As (3) holding the antenna end of the 528-3210 Cable As to the 436-8073 Bracket As.
Illustration 4 g06320669
Left side RC mode indicators
(4) 7K-1181 Cable Strap
Remove the three 7K-1181 Cable Straps (4) holding the 528-3210 Cable As to the 436-8074 Bracket.
Illustration 5 g06320670
Rear of the ROPS
(5) 527-6937 Base
Attach a 527-6937 Base (5) to the rear of the ROPS.
Illustration 6 g06320675
Rear of the ROPS
(6) 528-3210 Cable As
Reroute the 528-3210 Cable As (6) to the left side work light bracket.
Illustration 7 g06320678
Rear of the left side work light bracket
(3) Nut from the 347-6377 Connector Receptacle As
Connect the 528-3210 Cable As (6) to work light bracket and tighten down the nut from the 347-6377 Connector Receptacle As (3).
Illustration 8 g06320682
Rear of the left side work light bracket
(7) 117-6512 Grommet
Attach a 117-6512 Grommet (7) to the 528-3210 Cable As (6).
Illustration 9 g06320687
Rear of the left side work light bracket
(4) 7K-1181 Cable Strap
Secure the 528-3210 Cable As (6) to the machine at the locations indicated in Illustration 9 using 7K-1181 Cable Straps (4).