SHAFT AS-OUTPUT 1655634 - Caterpillar

"Maintenance Indicator Mode"
The ECM records data that is related to the vehicle's maintenance. If Distance is selected, all maintenance indications on the service tool will be displayed in distance. Typical maintenance indications are PM 1, PM 2 and the Cooling System Clean/Flush.If Hour is selected, all maintenance indications on the service tool will be displayed in Hours. Typical maintenance indications are PM 1, PM 2 and the Cooling System Clean/Flush. The ECM provides PM 1 maintenance interval and last maintenance information.
Table 1
Alternative     Default    
Manual Distance
Manual Hours
Automatic Distance
Automatic Hours     Off    "PM 1 Interval"
The "PM 1 Interval" allows a maintenance interval (PM 1) to be specified by the user. This parameter ("PM 1 Interval") must be programmed only when the Maintenance Indicator Mode is programmed to a Manual Mode (Distance or Hours).
Table 2
Manual Distance    
Minimum     Maximum     Default    
8050 km (5000 miles)    
56325 km (35000 miles)    
24140 km (15000 miles)    
Table 3
Manual Hours    
Minimum     Maximum     Default    
100     750     300    "Engine Oil Capacity"
The "PM 1 Interval" can be determined by the ECM. The ECM bases the "PM 1 Interval" on fuel usage. This parameter ("PM 1 Interval") must be programmed only when the Maintenance Indicator Mode is programmed to an Automatic Mode (Distance or Hours). Capacity of the sump influences the maintenance interval.
Table 4
Minimum     Maximum     Default    
19 L (20 qt)    
57 L (60 qt)     Refer to Table 5.    
Table 5
Engine Model     Default    
C-10 and C-12    
34 L (36 qt)    
C-15    
38 L (40 qt) (1)    
( 1 ) The C-15 Engine with a Front Sump BrakeSaver should be programmed to 49 L (52 qt).