SHAFT 1946847 - Caterpillar

Removal Procedure
Accidental engine starting can cause injury or death to personnel working on the equipment.To avoid accidental engine starting, disconnect the battery cable from the negative (-) battery terminal. Completely tape all metal surfaces of the disconnected battery cable end in order to prevent contact with other metal surfaces which could activate the engine electrical system.Place a Do Not Operate tag at the Start/Stop switch location to inform personnel that the equipment is being worked on.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00782255
Release the air pressure in the system.
Disconnect the hose assembly from the fitting (1) .
Illustration 2 g00782324
Fasten a strap and a suitable lifting device to starter (3). Remove three bolts (2) and the starter from the flywheel housing. The weight of the starter is approximately 54 kg (120 lb).
Remove the gasket from the starter.Installation Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install a new gasket on the starter.
Illustration 3 g00782324
Fasten a strap and a suitable lifting device to starter (3). Install the starter into the flywheel housing and three bolts (2) . The weight of the starter is approximately 54 kg (120 lb).
Illustration 4 g00782255
Connect the hose assembly to the fitting (1) .