SHAFT-PLANETARY 1994689 - Caterpillar

Specifications
Illustration 1 g01490553
Table 1
Specification for 295-9423 Swing Cushion Valve Gp
Item Qty Part Specification Description
- - - Operating voltage is 24 VDC.
- - - Resistance at 20 °C (68 °F) is 34.0 0.5 Ohms.
1 8 - Tighten the mounting bolt to 98 N m (72 lb ft).
2 2 - Tighten the mounting bolt to 6.9 N m (61.1 lb in).
Illustration 2 g01490573
Table 2
Item Qty Part Specification Description
3 2 8T-0288 Bolt Torque to 6.9 0.7 N m (61.1 6.2 lb in).
4 6 8T-6759 Pipe Plug Torque to 9.0 0.9 N m (79.7 8.0 lb in).
5 2 315-4413 Orifice Apply blue Loctite 242 to the threads.
Torque to 6.9 0.7 N m (61.1 6.2 lb in).
6 2 173-3536 Relief Valve Gp Torque to 69.0 6.9 N m (50.9 5.1 lb ft). Removal Procedure
Table 3
Required Tools
Tool Part Number Part Description Qty
A 311-1362 Vacuum Gauge Gp 1 Start By:
Release the hydraulic system pressure.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Illustration 3 g02380216
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 4 g02396716
Disconnect hose assemblies (1), harness assembly (5), and bracket (4).
Remove bolts (3), swing cushion valve (2), and the O-ring seals.
Illustration 5 g02396717
Remove crossover relief valves (6).
Remove bolts (7) and solenoid valve assembly (8).Installation Procedure
Install swing cushion valve (2) in the reverse order of removal.
Tighten bolts (7) to a torque of 7 1 N m (62 9 lb in).
Tighten crossover relief valves (6) to a torque of 69 N m (51 lb ft).