SHAFT 1H8393 - Caterpillar

Illustration 9 g00691722
Install valve spool (23) in body assembly (21) .
Illustration 10 g00691724
Install the O-ring seal on detent assemblies (24). Use a 3/8 inch - 16 NC bolt to install the detent assemblies on each side of the body assembly.
Illustration 11 g00691725
Put stop (26) in position in the body assembly. Install pin (25) in order to hold the body assembly in place. Install the pin until the pin is 3.0 mm 1.0 mm (0.12 inch 0.04 inch) below the surface of the body assembly.
Illustration 12 g00691736
Install valve spool (27) in body assembly (21) .
Illustration 13 g00691737
Install the O-ring seal on detent assemblies (28). Use a 3/8 inch - 16 NC bolt to install the detent assemblies on each side of the body assembly.
Illustration 14 g00691739
Put stop (29) in the body assembly. Install pin (30). Install the pin until the pin is 3.0 mm 1.0 mm (0.12 inch 0.04 inch) below the surface of the body assembly.
Illustration 15 g00691740
Put plate (33), body assembly (21), and plate (32) in position on manifold (35) .
Put support (34) in position on the plate. Install 22 bolts (31). Tighten the bolts to a torque of 30 N m 4 N m (22 lb ft 3 lb ft).
Illustration 16 g00691742
Put shaft (37) in position in bracket assembly (38). Align the hole in the shaft with the hole in the bracket assembly. Install pin (36) .
Illustration 17 g00691743
If bearings (40) and (41) were removed, use Tool (B) to install the bearings in lever assemblies (39) .
Illustration 18 g00691744
Put lever assemblies (39) and washers (43) in position. Use Tool (C) to install snap ring (42) .
Illustration 19 g00691747
Align the lever assemblies with valve spools (23) and (27). Put bracket assembly (38) in position. Install four bolts (44). Tighten the bolts to a torque of 30 N m 4 N m (22 lb ft 3 lb ft).
Illustration 20 g00691748
Install the O-ring seals on sleeves (46). Put the sleeves and washer (45) in position in the body assembly. Install the bolt that holds the parts in place.
Illustration 21 g00691750
Install elbow (49) in the body assembly.
Install the O-ring seals on sleeve (47) and (48). Install the sleeves in the body assembly and the elbow, as shown.End By: Install the transmission hydraulic control valve. Refer to Disassembly and Assembly, "Transmission Hydraulic Control Valve - Install".