SHAFT-MEASURNG 1U5847 - Caterpillar

Illustration 1 g03646083
Tube assembly with plastic section incorporated between the two steel sections
Turn the fuel supply to the OFF position.
Turn the battery disconnect switch to the OFF position.
Illustration 2 g03722979
Typical example
Illustration 3 g03722980
Typical example
Remove bolt (1) from the clip for tube assembly (6) .
Remove nut (3) from the clip for tube assembly (6). Remove nut (2) from bolt (8) .
If necessary, disconnect fuel injection line at fuel injection pump in order to improves access. Use Tooling (A) in order to plug the open port in fuel injection pump.
Remove tube assembly (6) from fuel injection pump (16) and secondary fuel filer assembly (5) .
Use Tooling (A) to cap the connection on secondary fuel filer assembly (5). Use Tooling (A) to cap the connection (15) on fuel injection pump.
Disconnect tube assembly (9) from secondary fuel filer assembly (5) .
Use Tooling (A) to cap the connection on secondary fuel filer assembly (5). Use Tooling (A) to plug the tube assembly (9) .
Disconnect tube assembly (7) from secondary fuel filer assembly (5) .
Use Tooling (A) to cap the connection on secondary fuel filer assembly (5). Use Tooling (A) to plug the tube assembly (7) .
Remove bolt (11) from bracket (10). Remove spacer (12). Remove bracket (10). Remove tube assembly (7) from clip (17) .
Remove bolts (8) for secondary fuel filer assembly (5). Remove spacer (4) from bracket (14). Remove secondary fuel filer assembly (5) .
Remove bolts (13) from bracket (14). Remove bracket (14) .Installation Procedure
Illustration 4 g03646163
Typical example
Remove the plug from the fuel connection. Install the new 439-8115 Fuel Line (1) to fuel connection (2). Orientate the tube assembly such that the fourth leg at Position (X) is vertical. Refer to illustration 4. Tighten the tube nut finger tight.
Illustration 5 g03646171
Typical example
Position bracket (4) onto the cover of the inlet manifold.
Install 6I-0260 Bolts (3) to the bracket (4). Tighten the bolts to a torque of 22 N m (195 lb in).
Illustration 6 g03645420
Typical example
Position the bracket (5) onto bracket (4) .
Install nuts (6). Tighten the nuts to a torque of 44 N m (32 lb ft).
Install bolt (7) finger tight.
Illustration 7 g03646753
Typical example
Position secondary fuel filter base (9) onto bracket (5) (not shown). Ensure that the end of 439-8115 Fuel Line (1) correctly installed into secondary fuel filter base (9). Tighten the tube nut for 439-8115 Fuel Line (1) finger tight.
Install two bolts (8) to secondary fuel filter base (9) finger tight.
If necessary, use slotted holes in the secondary fuel filter base (9) to achieve optimum position. Tighten bolts (8) to a torque of 44 N m (32 lb ft).
Ensure that 439-8115 Fuel Line (1) is still in the correct position. Tighten the compression nuts on 439-8115 Fuel Line to a torque of 27 N m (239 lb in).
Tighten bolt (6) (not shown) for clip to a torque of 22 N m (195 lb in). Refer to Illustration 6.
Remove cap from connection for plastic tube assembly (10) on secondary fuel filter base (9). Remove plug from plastic tube assembly (10). Connect the plastic