SHAFT-FUEL CONTROL 1W4342 - Caterpillar

Illustration 13 g06250150
Install ball (27), spring (28) into housing (24). Install adjustment screw (26) into housing (24) to the depth determined in the disassembly procedure.
Illustration 14 g06250146
Install cap (25) and the seal onto housing (24). Tighten cap (25) to a torque of 15 1 N m (133 9 lb in).
Illustration 15 g06250134
Position the pump in a vertical position. Install housing (24) and bolts (23). Tighten bolts (23) to a torque of 68 7 N m (50 5 lb ft).
Illustration 16 g06250129
Install bracket (22) and bolts (21). Tighten bolts (21) to a torque of 68 7 N m (50 5 lb ft).
Illustration 17 g06250128
Install shaft (20).
Illustration 18 g06250101
Install seal group (19) into bearing carrier (16).
Illustration 19 g06250091
Install fittings (18), (17), and the O-ring seals into housing (10). Install bearing carrier (16) into housing (10). Install O-ring seal (15) into housing (10).
Illustration 20 g06250087
Invert housing (10) and install shaft assemblies (14) into housing (10).
Illustration 21 g06250081
Install seal group (13) into bearing carrier (12).
Illustration 22 g06250077
Install bearing carrier (12) and O-ring seal (11) into housing (10).
Illustration 23 g06250073
Install housing (10).
Illustration 24 g06250064
Illustration 25 g06250052
Install O-ring seal (9), back up ring (8), and O-ring seal (7) onto valve (6). Install valve (6) into end cap (5).
Illustration 26 g06250452
Install end cap (5) and bolts (4) onto pump (3). Tighten bolts (4) to a torque of 55 3 N m (41 2 lb ft).
Illustration 27 g06250449
Install bracket (2) and bolts (1) onto the pump. Tighten bolts (1) to a torque of 55 3 N m (41 2 lb ft).End By:
Install the gear pump.