SHAFT-FAN 1W5038 - Caterpillar

When Required
Engine Air Intake System - Clean, replace elements Ether Starting Aid (If Equipped) - Installing cylinder Fuses and Circuit Breakers - Replace fuses, reset breakers Fuel System - Service when loss of power occurs Cutting Edges and End Bits - Replace if worn or damaged Ripper Tips - Replace if worn or damaged Radiator - Clean or replace pressure cap, clean core Transmission System - Clean screens Windshield Wipers and Washer (If Equipped) - Inspect wiper blades, fill washer bottle Winch (If Equipped) - Install wire rope cable Used Filter Inspection - Inspect for debrisEvery 10 Service Hours or Daily
Walk-Around Inspection - Inspect machine Engine Crankcase Oil - Check oil level Transmission System Oil - Check oil level Hydraulic Tank Oil - Check oil level Radiator - Check coolant level Fuel Tank Drain Valve - Drain water and sediment Seat Belt - Inspect for wear or damage Indicators and Gauges - Test Winch (If Equipped) - Check oil level Back-up Alarm - Test Cab Air System - Clean filtersEvery 50 Service Hours or Weekly*
Track Pins - Inspect Ripper Linkage and Cylinder Bearings - Lubricate Power Angling Tilt Dozer Hinge Pins - Lubricate Power Angling Tilt Dozer - Singletree - Lubricate Equalizer Bar Center Pin - LubricateEvery 250 Service Hours or Monthly*
Engine Oil and Filter - Change oil and filter. If sulfur content in the fuel is more than 1.5 percent by weight, use an oil with a TBN of 30 and reduce the oil change interval by one half Coolant System - Add supplemental coolant additive Final Drives - Check oil level Transmission Filter - Change filter element Brakes - Test Brake Holding Ability Tracks - Adjust Fan Drive Bearing - Lubricate Air Conditioner (If Equipped) - Test Fan and Alternator Belts - Inspect, adjust, replace Batteries - Check electrolyte level Bulldozer Tilt Brace - Lubricate Equalizer Bar Pins - Lubricate Engine Valve Clearance Settings - Adjust on new, rebuilt or reconditioned engines at first oil change, then at normal interval thereafterEvery 500 Service Hours or 3 Months*
Pivot Shaft - Check oil level Hydraulic System - Change filter Engine Crankcase Breather - Clean breather Recoil Spring Compartment - Check oil level Fuel System Filter - Change filter Fuel Tank Cap and Fill Screen - Clean Winch Filter and Magnetic Strainer (If Equipped) - Change element, wash magnet and strainerEvery 1000 Service Hours or 6 Months*
Transmission Oil - Change oil, wash breather Winch (If Equipped) - Change oil, wash breather Rollover Protective Structure (ROPS)/Falling Objects Protective Structure (FOPS) - Inspect Engine Valve Clearance Setting - AdjustEvery 2000 Service Hours or 1 Year*
Final Drives - Change oil Hydraulic Tank Oil - Change oil Engine Valve Rotators - Check Track Roller Frame Guides - Measure wearEvery 3000 Service Hours or 2 Years*
Cooling System Coolant - Change coolant, clean system* First Perform Previous Service Hours Items