SHAFT-DRIVE 2558575 - Caterpillar

Installation Procedure
Verify that all of the components are clean and free of foreign material prior to installation. Inspect all O-ring seals and all components for damage. Replace the O-ring seals and the components, if necessary.
Lubricate all O-ring seals with the lubricant that is being sealed.
Illustration 1 g00615371
Install check valve (13) to electric drive pump (1) .
Position bracket assembly (12) to electric drive pump (1), as shown. Install two bolts (14) and the washers that hold bracket assembly (12) to electric drive pump (1) .
Illustration 2 g00615368
Position electric drive pump (1) and bracket assembly (12) to the frame assembly, as shown. Install two bolts (11) and the washers that hold bracket assembly (12) to the frame assembly.
Illustration 3 g00615364
Position three hose assemblies (8), (9), and (10), as shown. Install bolt (7), the nut, the washers, and the clips that hold three hose assemblies (8), (9), and (10) to plate (6) .
Illustration 4 g00615363
Connect two hose assemblies (4) and (5) to electric drive pump (1) .
Illustration 5 g00615362
Position wire harness (2), as shown. Install two nuts (not shown) and the washers that hold wire harness (2) to electric drive pump (1). Position two rubber boots (3), as shown.
Fill the hydraulic tank with hydraulic oil. Refer to Operation and Maintenance Manual, "Hoist, Torque Converter and Brake Tank Oil - Change" for the correct procedure.
Charge the air pressure in the air tank. Refer to Operation and Maintenance Manual, "Starting With An External Air Supply" for the correct procedure.
Personal injury or death can result from air in the oil for the brake hydraulic system.Air in the system can prevent complete brake application and it is possible that the wheels on the machine can not be stopped.Air must not be in the oil for the brake hydraulic system to function properly.
Purge the air from the hydraulic oil in the brake hydraulic system. Refer to Air System and Brakes, Systems Operation, Testing and Adjusting, "Brake System Air - Purge" for the correct procedure.End By:
Remove the truck body retaining cable. Refer to Disassembly and Assembly, "Truck Body Retaining Cable - Remove and Install".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".