2676736 SHAFT-PINION Caterpillar parts
318E L, 319D, 319D L, 319D LN
Rating:
Alternative (cross code) number:
CA2676736
267-6736
2676736
CA2676736
267-6736
2676736
Weight: 58 pounds 26 kg.
EXCAVATOR,
Number on catalog scheme:
7
For full view, you need register
Information:
Illustration 1 g03551457
Schematic for the WIF sensor
Illustration 2 g03551458
Pin locations on the P1 connector for the WIF sensor (33) Sensor return (44) WIF sensor signal
Illustration 3 g02857417
Connector for the WIF sensor (1) Sensor signal (2) Battery + (3) Sensor return
Table 1
Troubleshooting Test Steps Values Results
1. Inspect Electrical Connectors and Wiring
A. Turn the keyswitch to the OFF position.
B. Thoroughly inspect the connector for the WIF sensor and the P1/J1 ECM connector. Refer to Troubleshooting, "Electrical Connectors - Inspect".
C. Perform a
45 N (10 lb) pull test on each of the wires that are associated with the WIF sensor.
D. Check the screw for the ECM connector for the correct torque of
5 N m (44 lb in).
E. Check the harness for abrasions, for pinch points, and for corrosion.
Loose connection or damaged wire
Result: There is a fault in a connector or the wiring.
Repair any faulty connectors or replace the wiring harness. Ensure that all of the seals are properly in place and ensure that the connectors are correctly coupled.
Use the electronic service tool to clear all logged diagnostic codes and verify that the repair eliminates the fault.
Result: All connectors, pins, and sockets are correctly coupled and/or inserted. The harness is free of corrosion, abrasion, and pinch points.
Proceed to Test Step 2.
2. Check For Active Diagnostic Codes
A. Turn the keyswitch to the OFF position.
B. Connect the electronic service tool to the diagnostic connector.
C. Turn the keyswitch to the ON position. If the engine will start, then run the engine.
D. Wait for at least 1 minute.
E. Monitor the active diagnostic code screen on the electronic service tool. Check and record any active diagnostic codes.
Diagnostic codes
Result: There are no active event codes for the WIF sensor.
There may be an intermittent fault.
Refer to Troubleshooting, "Electrical Connectors - Inspect" in order to identify intermittent faults.
Result: An E232-1 or E232-2 event code is active.
Refer to Troubleshooting, "Fuel Contains Water" before continuing with this procedure.
Proceed to Test Step 3.
3. Create an Open Circuit at the Sensor Connector
A. Turn the keyswitch to the OFF position.
B. Disconnect the WIF sensor connector.
C. Run the engine for at least 1 minute.
D. Use the electronic service tool to check for an active E232-x event code.
E. Turn the keyswitch to the OFF position.
Diagnostic codes
Result: The E232-x event is no longer active.
Install a replacement WIF sensor.
Use the electronic service tool to clear all logged event codes and verify that the repair eliminates the fault.
Result: The E232-x event code is still active with the sensor disconnected.
Proceed to Test Step 4.
4. Check the Wiring for a Short Circuit
A. Turn the keyswitch to the OFF position.
B. Disconnect the WIF sensor connector. Disconnect the P1 connector.
C. Use a suitable multimeter to measure the resistance between P1:43 and all other terminals on the P1 connector.
Greater than 100 Ohms
Result: At least one of the resistance measurements is less than 100 Ohms. There is a short in the wiring between the sensor connector and the P1 connector.
Repair the
Caterpillar parts catalog:
Parts shaft Caterpillar catalog:
311, 311B, 311C, 312, 312B, 315, 315B L, 315C, 315D L, 316E L, 317, 317B LN, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C L, 320D, 320D FM, 320D GC, 320D L...
315, 315B L, 315C, 315D L, 317, 317B LN, 318B, 318C, 319C, 319D, 319D LN, 320 L, 320B, 320C, 320D, 320D FM, 320D L, 320D2, 322B LN, 322C, 323D L, 323D LN, 323D2 L, 324D, 324D L, 324D LN, 325D, 329D L,...
315C, 315D L, 318B, 318C, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 3...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 311C, 313D2 LGP, 315C, 315D L, 316E L, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320 L, 320B, 320C, 320C FM, 320C ...
311C, 313D2 LGP, 315C, 315D L, 316E L, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, ...
311C, 313D2 LGP, 315C, 315D L, 316E L, 318B, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320...
311C, 311D LRR, 312C, 312C L, 312D, 312D L, 313D, 314C, 314D CR, 314D LCR, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN...
311D LRR, 312C, 312C L, 312D, 312D L, 313D, 314D CR, 314D LCR, 315C, 315D L, 318C, 318D L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D...
318C, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LR...
318C, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320...
318C, 318E L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 320D2, 320D2 GC, 320D2 L, 320E, 320E L, 320E LN, 320E LRR, 320...
3689996
SHAFT-DRIVE
311D LRR, 311F LRR, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 316E L, 318D L, 318D2 L, 318E L
311D LRR, 311F LRR, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 314D CR, 314D LCR, 314E CR, 314E LCR, 316E L, 318D L, 318D2 L, 318E L
3640979
SHAFT
315D L, 316E L, 318D L
315D L, 316E L, 318D L
3481871
SHAFT
313D2 LGP, 315D L, 316E L, 318D L, 318D2 L, 318E L, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D2, 320D2 GC, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D2 L, 325D, 329D ...
313D2 LGP, 315D L, 316E L, 318D L, 318D2 L, 318E L, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D2, 320D2 GC, 320E, 320E L, 320E LN, 320E LRR, 320E RR, 323D L, 323D2 L, 325D, 329D ...
3054931
SHAFT AS-ROCKER ARM
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN
2941721
SHAFT
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
311D LRR, 312D, 312D L, 313D, 314D CR, 314D LCR, 315D L, 318D L, 319D, 319D L, 319D LN, 320D, 320D FM, 320D FM RR, 320D GC, 320D L, 320D LN, 320D LRR, 320D RR, 321D LCR, 323D L, 323D LN, 323D SA
2945348
SHAFT-IDLER
308D, 308E, 308E CR, 308E SR, 308E2 CR
308D, 308E, 308E CR, 308E SR, 308E2 CR
3611155
SHAFT
307D, 308D, 308E2 CR
307D, 308D, 308E2 CR
3338040
SHAFT-AXLE
M313D, M315D 2
M313D, M315D 2
3219007
SHAFT
M318D MH, M322D, M322D MH
M318D MH, M322D, M322D MH
320B FM LL, 320C FM, 325B L, 325C, 325C L, 325D MH, 330B L, 330C L, 330C MH, 330D MH, 345B, 345B II, 345B II MH, 345C, 345C MH, 350 L, 365B, 365B II, 365C L MH, 375 L, 385C L MH, M318D MH, M322D MH, M...
3510814
SHAFT-DRIVE
M318D, M318D MH, M322D, M322D MH
M318D, M318D MH, M322D, M322D MH
2758159
SHAFT GP-MOTOR
M315D, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH, M330D
M315D, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH, M325D L MH, M325D MH, M330D
3338042
SHAFT-AXLE
M315D, M316D, M317D 2, M318D, M318D MH
M315D, M316D, M317D 2, M318D, M318D MH