SHAFT-BEVEL PINION 2710435 - Caterpillar

52. Put the housing in position in a press. Use tool (E) to remove bearing (58) from the housing.Assemble Torque Converter
1. Inspect all parts for wear or damage. Make a replacement if necessary. 2. Make sure the ring is in the outside bearing race. Use tool (E) to install bearing (58) in the housing until the ring makes contact with the surface of the housing.3. Install the top bearing race and bearing retainer (57) in the torque converter housing. Install the bolts that hold the retainer in place. Tighten the bolts to a torque of 50 7 N m (37 5 lb.ft.). 4. Install bearings (50) in flange (60) with tooling (B) and a press. Dimension (X) must be 9.00 mm (.354 in.). Dimension (Y) must be 76.0 mm (2.992 in.).5. The inside diameter of the bearings must be 69.939 0.044 mm (2.7535 0.0017 in.) after assembly. 6. Heat seal carrier (50) and bearing race (61) to a maximum temperature of 150° C (302° F). Install the seal carrier and bearing race on the flange. 7. Put ring (52) in position in the groove of flange assembly (48). 8. Install ring gear (62) on the flange assembly. Make sure ring (52) is in alignment with the groove in the ring gear. Install the two pins that hold the ring in place.9. Install seal ring (49) on the seal carrier (50). 10. Install tooling (B) on the housing. Lower the housing onto flange (48). The weight of housing (47) is approximately 57 kg (126 lb.). 11. Install bearing race (63) with a hammer and a brass punch. 12. Install guide bolts (64) in hub (46).13. Use a press and tooling (E) to install hub (46) in turbine (45). Install the bolts that hold the turbine to the hub. Tighten the bolts to a torque of 120 15 N m (90 11 lb.ft.). 14. Install turbine assembly (45) into housing. Align the spline on the hub with the splines on the flange assembly. 15. Put clean SAE 30W oil on the flange threads, the washer and the nut before the washer and nut are installed. Install the washer and spanner nut (44). Align the grooves (slots) in the flange with teeth in the washer. 16. Use one of tool (B) and a hoist to hold the housing in position.17. Install two 3/8" - 16 NC forged eyebolts (65) with jam nuts in the housing as shown.18. Use tooling (F), and tighten the nut to a torque of 985 35 N m (725 26 lb.ft.). 19. Install setscrew (41) into one of the holes in the washer. Move the metal over (stake) the setscrew in position with a hammer and punch. 20. Heat bearing cone (40) and seal carrier (39) to a maximum temperature of 150° C (302° F), and install them. Align the hole in the seal carrier with the hole in carrier (66). Install the pin that holds the carriers in