SHAFT AS 2822702 - Caterpillar

Removal Procedure
Start By:
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Open the front door on the right side of machine.
Illustration 1 g00592649
Disconnect tube assembly (2) and (4) from fuel transfer pump (3) .
Remove two bolts (1) from fuel transfer pump (3) .
Remove fuel transfer pump (3) .
Remove the O-ring seal from fuel transfer pump (3) .Installation Procedures
Note: Lubricate the bore lightly with lubricant.
Illustration 2 g00592649
Put clean engine oil on the O-ring seal. Install the O-ring seal on fuel transfer pump (3) .
Install fuel transfer pump (3) and install two bolts (1) .
Connect tube assembly (2) and (4) .
Close the front door on the right side of machine.End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect" for the machine that is being serviced.