SHAFT 2966195 - Caterpillar

Illustration 12 g02631558
Assemble two elbow assemblies (49) to the blade with two locknuts (50) .
Illustration 13 g02631779
Assemble hose (47) with the 45° end of the hose on the rod end of the cylinder. Use an O-ring seal (51), two flange halves (59), four washers (60) and four bolts (65). Assemble hose (48) with the 90° end of the hose on the head end of the cylinder. Use an O-ring seal (51), two flange halves (59), four washers (60) and four bolts (65) .
Illustration 14 g02642456
Assemble the guard (45) onto the tilt cylinder. Use two bolts (58), four washers (61), and two nuts (67). Assemble the hose clips (52), and (53), and grommet (54) by using bolt (64), nut (62), and washer (68) .
Illustration 15 g02631859
Assemble two hoses (46). Use existing hardware and two O-ring seals (51). Assemble two clips (52) and (53) and two grommets (54) to the outside plate on the radiator guard by using two bolts (64) and two washers (68). Assemble the grommet (55) and the clips (56) and (57) to the rear of the blade by using two bolts (63) and two washers (66). Orient clips (56) and (57) so that the hoses are close to the back of the blade as shown in illustration 12.
Illustration 16 g02635381
Assemble hose guard onto the hoses as illustrated.Note: The hose guard should be located between points (C) and (D) on the hoses.Note: The hose guard should be located between points (F) and (G) on the hoses.Shimming Procedure
Push Arm and Stabilizer Link
Illustration 17 g00292740
Remove all of the shims from push arm (1) .
Remove excess rust and paint from the contact surfaces of these components: the push arm, the cap and the shims.
Install push arm (1) and cap (2) on trunnion (3) without shims. Use the largest torque from the following list in order to tighten the bolts.
5 percent of the specified torque
50 N m (37 lb ft)Maintain equal distance on both space (A) and space (B) of cap (2). Insert the maximum number of shims into spaces (A) and (B) in order to determine the required number of shims.
Remove the bolts that are on cap (2). Insert shims into spaces (A) and (B). Add one additional shim to space (A). Add one additional shim to space (B). When possible, use an equal number of shims for spaces (A) and (B) .Note: The number of shims at space (A) must be within one of the number of shims at space (B). For example, if space (A) has eight shims, space (B) must have seven, eight, or nine shims.
Tighten the bolts on bearing cap (2) to a torque of 1800 200 N m (1330 150 lb ft).
The push arm should move freely on the trunnion. The specified minimum tolerance is 0.25 mm (0.010 inch).Note: You may be need to remove one or more shims after a short period of machine operation. Wear can be caused by normal vibrations of the surface or variations in the thickness of the paint.Lift Cylinder
Illustration 18 g03660565
(4) Nut (5) Bolt