SHAFT 2F0229 - Caterpillar

Illustration 16 g00857692
209-5042 S Shank Gp
Install bolts (23) and bracket (24) on the frame.
Install shank (21) through bracket (24) and install bolt (23) through shank (21) .
Install bracket (19) onto bolts (23) .
Install the washers and nuts (22) .
Install bolt (20), the washer, and nut (18) .
Tighten the nuts for all of the bolts.
Illustration 17 g00853316
Hitch (trailing behind)
Refer to Illustration 17 in order to install the hitch (trailing behind). Attach hitch (20) to the center section.
Attach the hitch (trailing behind) to support (19) that is anchored on the main frame.
Install wiring harness (18) and the associated hardware.Installation of the Harrow
This section provides general procedures for the installation of harrows that are available from your Caterpillar dealer.You must know the following information to successfully install a harrow:
Model of the implement
Size of the implement
Spacing of the shanks
Type of harrowReference: If necessary, refer to the Parts Manual in order to determine the fasteners that are used.Two types of harrows can be installed on the TL5 Series Field Cultivators:
Harrow (Tine As)
Spike
The Illustrations that accompany the Special Instruction provide the following information:Reference:
Spacing of individual bars for the harrow
Spacing of the hangers for the harrow
Offset of each bar for the harrowDetermine the Illustration that represents the harrow that is being assembled.
Position the row of bars that follow directly behind the implement.
Position the harrows in order to provide 190.50 mm (7.5 inch) between the sections.
Use the position of the bars in order to locate the hangers that are being installed on the implement.
Illustration 18 g00852867
Use the Illustrations to determine the mounting locations for hangers (2). The hangers should be positioned in order to avoid hinge (1), shanks (5), and frame members (6) .
Install the hangers. Use U-bolts (3) and nuts (4) to attach the hangers to the frame of the implement. Tighten the U-bolts evenly.
Illustration 19 g00853305
Harrow (Spike)
Illustration 20 g00852871
Harrow (Spike)
Illustration 21 g00856961
Harrow (Tine As)
Illustration 22 g00852872
Tine As
Assemble the row of bars that had been positioned behind the implement.Reference: Refer to Illustration 19 through 22 for the correct assembly of the harrow.
Assemble the remaining rows of bars.
Refer to the Operation and Maintenance Manual, "Harrow Attachments" for additional information for the adjustment of the harrow.Implement Configurations
A complete set of Illustrations separately accompany the Special Instruction. This special instruction does not contain a complete set of graphics that Illustrate each configuration. Illustrations 23 through 26 show a combination of each harrow and each spacing of the shanks.
Illustration 23 g00856973
Illustration 24 g00856977
Illustration 25 g00856974
Illustration 26 g00856981