SHAFT 2H9163 - Caterpillar

1. With the engine running, move the tilt control lever to put the bucket in the correct angle to dig and then move the tilt lever to the Hold position. Lower the bucket to the ground and stop the engine.2. Measure dimension (A) between magnet assembly (6) and switch assembly (5). The correct dimension is 5 2 mm (.20 .12 in).3. To change dimension (A), loosen bolts (2) then tighten screw (3) just enough and move tube assembly (1) and the switch away from magnet assembly (6) Switch assembly (5) and cover (4) must be vertically centered with magnet assembly (6)4. Move tube assembly (1) until the front edge of switch assembly (5) is even (flush) with the front edge of magnet assembly (6).5. Loosen screw (3) and tighten two bolts (2).