SHAFT-SPIRAL 2K8565 - Caterpillar

Required Tools
Table 2
Required Tools
Tooling Qty Part Number Description
A - - Loctite® 243 Machine Preparation
Park the machine on a level surface. Refer to the appropriate Operation and Maintenance Manual for the proper parking procedure.
Make sure that the machine remains off during this entire procedure.
Illustration 3 g06071912
Inspect the cab strut lock pin orientation. The open end of the lock pin must face towards the front of the machine and away from the fresh air intake. If the lock pin is facing the opposite direction, reverse the orientation of the pin.Note: Reorienting the lock pin as shown will pose less potential for injury during filter replacement.Cover Removal
Illustration 4 g06085302
Illustration 5 g06085343
Illustration 6 g06085367Installation Procedure
Illustration 7 g06085403
Illustration 8 g06085429
Illustration 9 g06086414
Illustration 10 g06086426
Illustration 11 g06086485
Illustration 12 g06086507
Illustration 13 g06086450
Illustration 14 g06086868
Illustration 15 g06086928Appendix
Raising the Cab
After the Air Conditioner Breather Kit has been installed, cover assembly (5) must be removed prior to lifting the cab. Failure to remove the cover assembly will result in damage to the cover assembly.Note: Dealers must inform customers: Do Not raise the cab without first removing cover assembly (5). Failure to remove the cover assembly will result in damage to the cover.Cleaning the Machine
Avoid allowing excess water to enter tube assembly (3) during any cleaning of the machine. Failure to do so could result in contaminating the fresh air filter. If the fresh air filter is contaminated, the filter will need to be replaced.